TelePresence and Video Infrastructure

I need some guidance on how to programming the Touch 10 API's with Creston equipment to control the Blinds and Lights.  Any starter material i could look into? Does it requires any programming on the Creston side as well?  If anybody can give me any ...

Have a request from a customer concerning connecting an external speaker to an MX300 G2 endpoint. Is this possible?

There were 4 users in calls (MS Lync, Lifesize 2 units, Cisco SX 20 )The call was initiated through  RMX bridge.When any participant was sharing the presentation the SX 20 was not able to receive the same.But when we do point to point call with any l...

Hello, Is there any documentation around the UCCapabilities attribut used by TMSXE to identify that a meeting is UC-enabled and therefore triggers the OBTP feature? I noticed under the reference here that the below content is generated but have found...

i can connect to CMS coSpace using USER URI PART ie auto.meet@conf.test.com.but after connecting to space, the display on top is not showing as "auto.meet's space" instead its showing as auto.meet@<ip address of CUCM subscriber> ie auto.meet@172.17.5...

Hi,   We have two SX80s running CE8.3.4 with CUCM 9.1.2.13900-10. Calls are working just fine, except that we cannot seem to pass DTMF tones on any call inside or outside of our network. We just inherited support of these devices, so I am not super f...

We are using SX10 codec & we need to use a balance line signal out from Biamp Nexia DSP as a Mic input to this codec. We are connecting 3 mics in Nexia DSP & mix Balance out will go to Mic In of SX10 codec for far end participants.  The 4 pin connect...

We have TMS 15.5.0 Cisco Meeting Server  2.3.2   Overview of my request:   I schedule a video conference in TMS Email is sent. Email contains Connection instructions which include the Meeting URL and conf_ID (VAL:WEB_CLIENT1_URL).   I list all video ...

Hi, a customer requested a configuration in basic HA using CMS 2.3.3 and VBrick Rev + DME. The desing includes 4 servers for CMS (2x with callbridge and other two for recording), 7 servers for VBrick Rev and 2 for DME. The customer want VOD and live ...

Hi everybodyI would like to create a video conference by using the Telepresence ServerHere is the backgroundA.CUCM 10.5B.Telepresence conductor x3.0.3C.Telepresence server 4.1(2.33) - VM- Enabled: Virtual machine activation- Enabled: Encryption- 5: S...

Hi, If i connect 2-3 mics to the sx80, can i mute only one or two of them? Thanks, Shy

Do versions of VCS 8 and above demand a VM? Will the new VCS-Expressway-C and E behave like the VCS C/E do today?  Can configuration files be ported over?  Licenses? Thanks Docs seem to say different things depending on what doc you look at.