TelePresence and Video Infrastructure

TMS with WebEx Prod Tool integration receiving error message There are not enough resources available to host this conference.  If WebEx is removed the error disappears. Does anyone know the solution to this problem.  

Dear all Anyboda an Idea how can I hcnage the SerialPort Baudrate on a MX300 G2 ? I getting allways the follwoing failure : xconfiguration SerialPort BaudRate: 115200*r Configuration (status=Error):*r Configuration Reason: "No match on address expre...

What is the DB9 connector for the COM port on the Cisco SX80 and what pin is Tx and Rx?

Hello. My organization has WebEx and we're currently on WBS30.4. We ahve also recently enabled CMR Cloud and as we enable the service on individual WebEx host accounts we're finding that there is a new version of Productivity Tools required for Windo...

Does anybody here know the maximum amount of entries a TMS phonebook source (filled using CSV file) can hold?I read 500 and 1000 once (twice actually :-)), but cannot remember where I found this and if this is still accurate.

Hello. On the SX80, is there a way to enable Do Not Disturb mode from the web GUI? We are running TC software. On the C-series codecs, this setting is available, and there is an on-screen indicator showing whether it is enabled or not both during a...

I am wondering if there's a way to save a Layout preset for when a Tandberg C40 goes into a period of inactivity so that that when it wakes it'll be configured back to a specific default screen layout. The issue is that we have many groups coming an...

Hi, I have a customer who has just purchased some MX300 VC endpoints (registered to CUCM) and also has Expressway. The endpoints have their own external IP addresses. We have tested dialling internally via extension numbers which is all fine. We need...

I have a Tandberg 1700 VTC system we are going to turn in and need to know, if when we take it off the network and power it down does it hold any of the networking or IP data within the system? And if so, how do we remove the IP data from the device?

hi all         I am deploying on premise CMR for our client.  When I make  video call from external video endpoint to CMR via expressway E. and expressway C , there is an error saying  "You have reached your license limit of 0 concurrent traversal ca...