TelePresence and Video Infrastructure

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Dear Support Community, i have the following Installation:CUCM Version 10.5(1)Telepresence Conductor Version XC2.3virtual Telepresence Server Version: 4.0(2.8)EX60 TC 7.1.4Cisco 9971, Firmware 9.4(1)SR1Some Other Phones (7962, 6941)All Endpoints are ...

r.rung by Level 1
  • 3641 Views
  • 4 replies
  • 0 Helpful votes

I have a Cisco Touch 8 tablet that is connected to an MX200 (G1) and we would like to install a handset to use for privacy. The tablet has the same connector like an EX90 handset but when we connect it to the MX200, it does not seem to recognize that...

cwade23 by Level 1
  • 269 Views
  • 3 replies
  • 0 Helpful votes

As to register Cisco jabber video for telepresence (movi client ) as a end point in VCS internally i did installed Telepresence management suite .And i do go for the installation without release key and it shows the license status as   LicensesTotal ...

HiWe've just implemented a small proof of concept with a Cisco VCS, TelePresence Conductor and 2 8710 TelePresence Server blades.I've configured a meet.* search rule on the VCS that points to conductor. This is all working properly.The client now ask...