TelePresence and Video Infrastructure

I've got the following setup working so far:Video endpoints registered to VCSMultiway to VCS using Conductor/TP ServerVCS registered endpoints can merge CUCM registered voice endpoints into a Multiway conferenceMy issue is with Active control/iX pass...

helloI am about to deploy 2 SX20 units for point to point video callsThe customer has a concern about multicast and the limitation that the Nexus has in regards to multicastI'm new to the SX20s and i haven't found a lot of information on how heavily ...

Is there a way to control how a VCS behaves after power is interrupted?  As in does it automatically restart or does it stay shut down?The reason I ask is because I have a client in a 'fringe' area where power can occasionally be a bit unreliable, an...

Hello! I have two sites. one with CUCM 7.1, the second is with the CME.I have video working inside the CUCM and inside the CME. but I have no video from CUCM to CME or from CME to CUCM over SIP trunk. only audio is working. please help me to understa...

Hello, I have an old platform with 1*MSE8510, VCS and many Profile 52. My customer is claiming that there is a dephasing between voice and video. The claim is also for voice during few seconds at startup of the conference call. There are some gaps in...

We have MCU 5310 version 4.4(3.67) and registered with CUCM as SIP trunk.Conference is working fine with both auto attendant and Static/permanent conference.Issue is: we have created permanent conference with number ID 3333 with PIN ex.1234. also Gue...

I have manual Phone book source created for bridge numbers but unfortunately someone has imported contacts from All systems phonebook source couple of times to this manual phonebook source. due to which when a contact is searched on the endpoint dire...

Hi There Can anyone tell me if the C Series codecs support direct Streaming to Multicast or Unicast protocols, the Older MXP used to have this feature that you could stream a cal direct from the codec. Also our client used to use the Web Snapshot fun...

Hi Folks,My client upgraded their MSE 8000 Supervisor Blade from 2.2 (1.17)  to: 2.3(1.32) and now they can't web into the blade any longer? I had them try different browsers and they tried IE and Firefox with the same results.  I also had them type ...