Hi,I tested the fresh version TC6.1 and it got some good bugfixes (like the SNMP bug on SX20) and some UI improvements. BUT there is a propably a new one in the Web UI: The call control window does only show an incoming call (ringing, established) in...
hi, ciscomen! just trying use tms provisioning extension for movi register Cisco TelePresence Management Suite Provisioning Extension Deployment Guide http://www.cisco.com/en/US/docs/telepresence/infrastructure/tmspe/install_guide/Cisco_T...
Anybody know the procedure to update the firmware on one of those VX Clinical Carts? I downloaded the bin file and the user guide states to use one of the USB slots on the rear interface, but I cant find anything else on how to apply the firmware fil...
Anybody have success getting their content\presentation to have good quality when dialed into an MCU? I was sharing an Excel spreadsheet and it looked like garbage. I enabled the setting "Automatically make content channel important" so its using t...
Hello,We have a Tandberg/Cisco environment containing about 60 endpoints, VCS, TMS but no central MCU.We are planning an upgrade of varoius bits as well as the addition of an MCU to handle increasing multisite needs but need to know the pattern of us...
Hello,We have an MCU 4505 having SIP trunk between CUCM, we had created conference on MCU.We have profile 65, EX90 and Cisco 9951's registered to CUCM.When we try to call MCU- Conference no. from cisco 9951 video phone its works perfectly, but when w...
Cisco,Will LDAP authentication ever be implimented in the MCU/TelePresence Server platforms for administrative tasks?We are trying to standardize our TelePresence administrative rules and we are finding some products support LDAP and some don't and s...
We have a VCS that will not load the firmware. I have tried to load the 2nd image but that fails too. I would like to re image the VCS completely but I'm unsure of the commands. I have a TFTP server that I can use but ideally I'm after a little guida...
hi,we have VCSc and VCSe in our environment, users will use jabber client outside office, those devices will be registered to the VCSe, and we have some c60 endpoints registered to VCSc.When jabber client calls C60 endpoint, then press end call from ...
Hi,if we want to have all the endpoints in remote sites registered to the VCS in the headquarter, when user makes call in remote sites, will the call route to headquarter first?Is there any concern (e.g. bandwidth) for this kind of deployment?thanks.
Dear All,We are willing to upgrade our VCS to Version 7.2.1,it will be interesting to get you feedback regarding bugs or any anomalies.Have you experienced problemes with this version?ThX
Hi,I have a problem where presence is not working between users registered on the VCSc and the VCSe.If a users registers on the VCSe, they can only see the presence of the VCSe registered users, and likewise, users registered on the VCSc can only see...
Hello!I have got 2 SX-20 units connecting directly to one another using IP addresses h.323. I want to limit bandwidth between the 2 units at 768kbps.So I have manually done it as follows:Settings > Call settings > Default call rate: 768kbpsProblem is...
