TelePresence and Video Infrastructure

Hello:My understanding is the TMS has an API that we can use to pull reportinginformation. I looked at cisco.com and the only TMS API I can finddocumentation on is the booking API. Is it the same interface? Can youplease point me to overview document...

Hi to allI will try to give you an idea what we have setup and what is the senario Central infrastracture : CTM,CTMS,CUCM,CUVC,2911 with 10 MB line for the external video callsEndpoints: 5 CTSWe want to establish a video conference with external vide...

Hi.Is it possible to use the 2.nd ethernet port on a c60 codec for sending x.commands to the codec.My problem is that the controlsystem (AMX) is on a separate, internal network.Regards.Henning Telving

Egypt does not observe daylight savings time as of April of 2011, however as of this April it still appears to be observed on our TMS 13.0 server.  All our Egypt endpoints have been adjusted to not observe DST.  And it has not impacted the connection...

Hi,I'm using C40 and C90 register to CUCM as a native client. When I call between these endpoints call never connected with 1080p resolution(it connected with 720p)But when I change the endpoints register to VCS, the call was connected with 1080p.I'm...

Hi,TMS cannot seem to scan the user to check the user group memberships, therefore I cannot apply any additional permisions outside the TMS default group.I do get the following error:13:48:03,186 [71] WARN  Tandberg.TMS.Framework.Service.UserGroup.Us...

I´d like to know if is possible to register E20 phones at CUCM server as a 2nd line.The 1st. line is registered at my VCS server and I have also a TMS to provisioning the Tandberg equipments.What I need to do for this integration ? There are some doc...

Hello,Can someone confirm with me that the microphone (CTS-QSC20-MIC) which you can purchase with the SX20 endpoint is connected via a 3.5mm.  If not, is it USB?  Lastly, how long is the microphone's cable?  I don't see any specific details on this m...

Hello,A customer is planning to buy some C60 and MX200 systems. They want us to provide them some layouts for the C60s to be sold. They sent us a template which I attached in this discussion. And I created a layout xml file using TC console (also att...

Hello Every OneI have CUCM 8.6 version and tandberg MCU TTC2-01(software V. d3.10) with only H.323 functionality. I want to use this tandberg box to make video conferening calls between CUCM end points. There is no such option in CUCM to add this har...

Hi All:I have a VCSE that is outside the firewall with an EX90, C40, and Polycom HDX 9000 registered to it from inside the firewall.I can make calls to external system from any of the three systems.I can make both SIP and H.323 calls from the outside...

Hi there,normally the RC would be set out of function, if I register a TouchPanel to (f.ex.) a C60 codec.Is there any possibility that allows to use the Remote Controller at the same time?Maybe with a hidden xconf or xcom command?(SW Vers. TC5.1.0) M...

Is it possible to assign individual numbers to Jabber users that aren't related to anything else?Looking through the options for provisioning in TMSPE, you can only set Device Address Pattern on a group level using things like Office Phone number or ...