Hi,I bought a D9036 from ebay, I found it's managment IP address and was able to open the browser but I don't know the username and password, is there any way to factory default this unit or reset the username and password, your help is appreciated.T...
Forum Posts
I'm getting the below error after loading my commoncert.cer to CMS when run a "PKI inspect" I posted a question early but at almost 100 views and no answer. I wonder if I'm asking the wrong thing. Attempting to set up CMS. WE have three server CMS1,2...
We’re planning to convert our Codec Pro devices, which currently use CVI (Cloud Video Interop) to connect to Teams, to MTR — since they support that, right?In this case, does the Room Navigator log in with the same M365 Teams account as the codec? Or...
Hi,has any one configured a encoder d9036? i need some help how does it work & how can i send the video over the ip.
Hello,I got 2 boxes of Cisco TelePresence MCU 5320 with a stacking cable. The cluster of them is not being formed due to the firmware version mismatch: 4.4(3.57) is the master, 4.5(1.75) is the slave.As these devices reached EoL many years ago, I can...
Using AMX Netlinx with a Cisco Pro Codec firmware 11.20 or higher via RS232 @ 115200 baud rate. The issue is AMX system not receiving incoming call data to trigger a popup page to allow user to answer call. This has happened across several system wit...
Looking to test my Codec Pro using a virtual machine or common node. Currently using only Web Interface to config for I do not have a touch panel.
Hi, We want to install 3x 4k PTZ's in our large conference space, I'd like to know if the resolution/refresh rate can be modified beyond the options of 30hz or 60hz.Powerline frequency in Australia is 50hz, thus the LED screen that's built in runs at...
Hi everyone, I have a Cisco camera, model CTS-CAM-P60, which I’ve connected to my local network. It’s now assigned the IP address 172.16.0.27. I’m trying to control the camera independently, without connecting it to a Cisco codec. Ideally, I’d like t...
I have an old DX80 that doesn't respond to finger touches. I performed a factory reset but that did not resolve the issue. Can I reinstall the firmware from a USB stick in hopes that this might resolve the touch screen not responding to finger touche...
I have consumer televisions connected to a Cisco Codec Pro with CEC enabled. When the codec is in standby mode, the TVs will wake up (with no signal) because the codec is checking the status of the TVs. I know this is a problem with the TVs misinterp...
Hello,I have several Cisco video conferencing systems, and the Navigator tablet is missing the keyboard for my region, Switzerland.More precisely, the Swiss-French keyboard.It's a rather specific QWERTZ layout.How do I add this layout?Thank you.
EIDT, this is for the WebEx platform. When an attendee mutes themselves, they retain the ability to unmute at will. The picture shows three attendee microphones, with the top and bottom mics only allowed to unmute when requested by a panelist. The ...
Hello,I’m encountering an issue when connecting my MacBook to a Cisco Room Bar using a USB-C to USB-C cable.The Mac detects the Room Bar correctly.Screen sharing works as expected.The Room Bar’s camera and microphone also work properly.However, there...
GreetingsI have followed the script that was posted on GitHub to create a Report an Issue button on the Touch 10 that integrates with ServiceNow to create an incident ticket I have the macro loaded but I keep getting the error: URL not allowed by rul...
