Hi,I need to reset the VMware root account password for the ESXi that came pre-installed on UCS C220 M4. Obviously I need this to configure the vmware network management and get through hypervisor's initial configuration. I have CIMC access. Is the E...
Forum Posts
Hi we have B200 M4 UCS servers, and we also have 2 sites (Same domain, but different Vlan information) I need to move 1 blade from the chassis in 1 site to the chassis in the other site. We also need to rename it, don't know what the steps are. Also,...
Hello, We have Cisco UCS 6200 series, I was configuring LDAP on it, and I guess I've missed it up, I've created a local domain, changed the native authentication from "local" to LDAP, saved and logged out to test LDAP user authentication, but all f...
Resolved! Boot device / boot media access
Hi folks, I need help! I can't get my server to boot to the ESXi iso. "Reboot and Select proper Boot device or Insert Boot Media in selected Boot device and press a key" Brand new UCS environment racked and cabled 2 weeks ago. 4 UCS C240 M4 S2 con...
Recently I updated Java on my Windows 8 PC from v7 to v8. After that I discovered that I was unable to connect anymore to Cisco UCS Manager due to security reasons (the certificate is not trusted, we can't let you connect to that extremely dangerous ...
Hello, I'm setting up a new UCS service profile, and I'm getting the error above. I've created WWPN pools, using the default prefix (one for FI-A, one for FI-B) and assigned them to the vHBA templates accordingly. thoughts?
HiWe have issue with connecting Fi to Nexus . 1 link is use for Fi - server and 1 link is for Fi to nexus . and configuration is : Fi to nexus : Fcoe vsan 100 and with ether channel , and ether channel and port is up and operational state is ok but ...
HiI am trying to install hyperflex but i got this error: Configuring HX serversError occurred while configuring UCSReason: Server configuration failure. Success count: 0. Failure count: 3Configuration Failed
Hi,i have new hyperflex cluster to deploy and i get this error in deploy validation step,my current configuration :UCSM 4.0(4h)HX Installer 4.0(2b)UCSC 4.0.4hESXI 6.0 factory installedthanks.
Has anyone tried two 16gb sticks on the UCS-E140-M2 with newest firmware 3.2.6 ? Looking to find a way to get more than 16gb max, hoping a firmware update will allow more. Thanks,Joe
Hello,I have to reboot an UCS-FI-6296UP via this command:FI-A# connect local-mgmt bFI-B(local-mgmt)# reboot how long does the reboot take please ? Thank you.
Configuration Notes: UCS v2.1(3f)x4 B200 M2 w/ M81KR VIC (Palo)4 vNICs provisioned per ESX host. 2 for Production traffic / 2 for Storage & vMotion (each are on separate vlans w/ no SVI, flat VLANs). Storage & vMotion vNICs: 1 connected to Fabric ...
adding more vHBAs to UCS Hi everyone,I'm trying to add a new vHBAs port because I'm planning to set vHBA(s) as passthrough from the Hypervisor to VMsWe have the following setup & equipment:1 x Cisco UCS 5108 Chassis4 x Cisco UCS B200 M5 Blades Server...
We have seen cases where customers experienced avoidable Hyperflex related outages because FI connected upstream ports did not have the correct spanning tree config. For Hyperflex related FI installs, Catalyst switches should have the "portfast" opti...
