I got VMs on the same vlan as the pxe/tftp serer but they are not pxe booting. I have the vlans right. how do I do a packet trace from the vm to the pxe server via the FI?
I have a UCS C220 M3SBE server and cannot get CIMC to work on it. When booting I can hit F8 and it will say its loading CIMC config utility but it never boots into it it just boots to the OS. I have tried multiple times. Is there a part CIMC needs po...
I have a couple of C240 M4's at remote offices and need to udpate firmware on them. I'd like to update CIMC first, then boot the HUU iso and update the rest of the firmware. However, I can only find the HUU download, there doesn't appear to be a wa...
Hey All, I just need to confirm that the Cisco C220 M5SX blades have embedded LSI controller, which hypervisor hides the drives from the ESXi installer? ESXi 5.5.0 (yes i know, environment limited) I have configured the drives in RAID 1, as a bootabl...
My question is specifically around how to tell if a call home xml alert is cleared or not.
I have noticed that in an alert,
there are several values which point to alert severity.
1. in the envelop body:
<soap-env:Body>
<aml-block:Severity>5</aml-blo...
Hello team! How are you? I have to configure a server c240-M5 with SMB services as storage to a few server blades in a mini UCS chassis.How would be the procedure/configuration in the ucs to commit this? I attached a topology.Thanks in advance, i was...
I am looking for a list of steps to replace a failed 6248 FI in a 3.1.3a UCSM environment. Got a new 6248 in an RMA from TAC but want to make sure we replace the failed FI with the right steps. Thanks for any guidance.
I need to get all serial number off the Cisco UCS environment (Chassis/blades/stand-alones) so I connected to the UCS Manager using my domain credentials and putty. I am using the command:show chassis inventory expand > FullInventory_2019-05-29 Only ...
We need to connect a UCS C220 server in a FI and reach a network. c220 servers 40gb slot are connected to 6332-16up 40 gb port. If I set the port to network uplink. my vms on other servers got lost connection. maybe because if Netwprk uplink configur...
Welcome to this Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about the Cisco UCS Manager 2.2(1) release, which delivers several important features and major enhancements in the fabric, comp...
Hello team, We are unable to install Ubuntu 14 04 on Cisco UCS C240 M5 server which has RAID configuration. RAID Controller Info: RAID bus controller: LSI Logic / Symbios Logic MegaRAID Tri-Mode SAS3516 (rev 01) We are unable to find driver for above...
New to working on servers and looking for advice. Start server (UCS C200 M2) up and it stalls at this screen. "Configuring and testing memory, please wait...completeConfiguring and testing platform hardware..." I have tried to do a BIOS rescue, howev...
Hello!I have a C220M3 on which I plan to install some Cisco UC Applications.Now I was wondering, is it concidered good practice to install the Hypervisor on that Flexflash card?Or is it better to install it on the DAS?I only have one Flexflash card. ...
Hi There,Cisco UCS 6248UP fabric interconnect comes with 12 ports Right to Use licenses. Also the latest firmware for UCS is available for download. Could you let me know if I am allowed to download and install the latest firmware & use the 12 licens...
