We recently deployed UCSC 2.0(1t) to evaluate as we haven't been satisfied with Intersight up to this point. I recall seeing some information while evaluating that "Some features require a valid license after the evaluation period" (or something to t...
Forum Posts
We have an issue in 1 of our backup server which is rack mount server UCS C240 M4SX integrated to UCSM managed through UCS Central, is not booting up. The KVM IP is also not pinging hence we are unable to launch KVM. Physically the server is up but f...
Hi,we need to chage the IP of UCS Central due to some conflict, but the UCS Manager is regsiterd in UCS Central using IP, how can we register with UCS Central FQDN without unregistering it?
Hi Everyone,I would like to know if the UCS C220 M5 server supports Intel Optane DC Persistent 128GB PC4-2666V DDR4 ECC Server RAM NMA1XXD128GPS memory module.I'm about to buy 2 modules but I'm newbie and this server is my homelab. best regards,Dougl...
Hi Everyone,my server is a UCS C220 M5L has LFF4-drives, however, when opening and checking the MegaRAID card I saw that it indicates 8i but have 2 cables with only 2 conectors each one are connected the 4 x 3.5" HDDs.Could I replace these cables wit...
I have a UCS 220 M4 rack server. I want to know if we can add a GPU to it and use it as a high-end GPU workstation. If yes, please help me with the compatible GPU and necessary accesories for the same.
Hello,I had an FI fail while in the middle of an upgrade via UCS Central. The FI rebooted and just refused to come back online, so it was replaced. The issue now is that I cannot get the FI to register properly with UCS Central. The FI is properly pa...
To host some VMware VMs that demand very low latency, I want to configure SR-IOV on one or more interfaces of B200-M4/M5 blades. However I can't find any instructions on how to do this. Been searching but the most recent instructions I can find are f...
Hi,I work on UCS Central 2.0(1q). My goal is to forward syslog in an encrypted fashion. I can't figure-out how to do that.Based on this documentation :https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-central/cli-reference-manual/2-0/b_...
Dear UCS expert,It is because browser is not supported Flash, so I upgraded CIMC with firmware & BIOS version to support HTML5.After upgrade, the UCS C240 M4S2 No Storage Disks & Only Show FlexFlash.Even, I made it fall back to downgrade CIMC, firmwa...
Hi,I've tried scrubbing servers a few times yet I never seem to find a proper repeatable way to scrub a server. Steps I've tried:First we activate the Scrub Policy that is set to Scrub Everything on the Service Profile.Then we try one or more of thes...
I have a UCS C240 M5SX that I have been using for testing our product. I had been doing OS installs on it and have been successful for the past couple of months. Now when I do an fresh OS install, the boot option is no longer present or available. ...
First time I have noticed this error and don't understand it and cannot find anything on the InterwebChanged the firmware version on a Host Firmware Package to 4.1(3i). When I select the Hardware compatibility Report the results are "Cannot Determin...
The only way I can get a mouse and keyboard to work is via vKVM / remote console. no amount of locally-attached USB mice or keyboards do anything once HUU is fully booted. Any ideas? I've tried it on multiple systems with the same behavior. Those...
Hi, We are experiencing issues with upgrading our individual standard-mount rack blade UCS servers. We know of an interface on their Hyperflex that allows remote upgrades of UCS servers. Could someone provide any documentation with procedures for a s...
