Hi folks,I have a 7926G SCCP community with a 2911 running CME v9.4 trying to talk to a new 7841 SIP community with a 4331 running CME v14.1.Skinny phones can talk to skinnys, SIPs can talk to SIPs. How do I get them to interwork, please?Andy
Dear all,I have an SPA112 which I would like to use in the following scenario:Multiple phones connected (can be to one port using splitters), two SIP providers configuredIncoming calls coming through provider1 should ring all connected phones (no inc...
We have a Cisco SPA 112 ATA connected to a Broadsoft hosted phone system.FW 1.4.1 SR5The ATA has a Hosiden Besson Bedlam Loud Tonecaller bell connected.The hunt group phones ring including the bell, the call is answered on the phone but the bell cont...
Was trying to switch versions from active 11.6.1.10000-51 to 12.5.1.10000-31 fails at 'Checking Pre-requistes' step with message: "ERROR: Switch version cannot be performed as SSH passwordless connection is not setup correctly between the two nodesSw...
Hello everybody,so Im pretty noobish when it comes to this topic so please bare with me.My dad recently bought a CISCO ATA 192 in order to integrate our analogue doorbell / speaker system into our IP phone system.so the bell has a momentary switch wh...
I manage several facilities that utilize one CP-8845 and one analog cordless phone plugged in behind an ATA-192. I have seen the data sheets on how to transfer calls FROM the analog device, but my question is: if a call is answered on the CP-8845, an...
My SPA 504G IP phone will not allow me to dial cisco and activate it with the code sent to my email. I have tried 3 phones and all 3 have updated to the latest firmware and still will not show any type of activation dial.
I have recently bought a SPA504G phone and set it up successfully for a single SIP extension. I'm using the 7.6.2f firmware which is the latest at time of posting. All works fine until a power outage and when the phone restarts it reverts to an outbo...
From my understanding, there is maximum 3 slots at ISR 4451 allow to insert 8 ports E1 card.Does it mean it could support 720 voice channels(30channel*8 ports*3 E1 cards) ?If not, what is the maximum voice channel support for ISR 4451 ?
hello all, I recently acquired a bunch of Cisco phones specifically SPA514G, SPA525G, and one CP-8851The phones are registered to Vodafone meaning in the status menu under customization they show Vodafone. after looking around I understand this is no...
Hi Cisco,I need to register my Cisco CP-7911G (SEP0026CB3D85D6) with the Xorcom PBX utilizing the SIP Protocol.Do you have any recommendations as I couldn't see SIP registration Account on the menu when I accessed WebGUI?Best Regrads,Jakkrin Karahong...
I've came across an old CISC U560 PBX and was asked to configure one thing here that I'm not sure whether it is even possible.All external incoming calls are forwarded to a specific extension (XX) and if not answered, they are forwarded to a "blast g...
I have a Cisco SPA 303 desk phone.It was originally set up using one provider and I have since switched to a different provider.I am attempted to set the phone up using its admin web interface.I have all of the settings required. I enter them into th...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: