Voice Systems and Accessories - Small Business

Hi all, I set up the line key 2 of a SPA504g to monitor/call an extension this way :(Asterisk PBX is used)  fnc=blf+sd+cp;sub=5004@$PROXY;nme=Grandstream;vid=1When I want to transfer the current call to extension 5004 , I simply press that line keyTh...

Is this possible to do?We have a client that currently has two branch offices and a UC540 at each.  They are consolidating these two branches into one office now.  The combined phones will exceed the UC540's 32 user limit.  So, can the two UC540 unit...

Is there a way to change what the source phone number is after it is forwarded?The business I am helping has the phones forwarded after hours to cell phones.  The problem right now is that when the after hours calls are forward the source number is t...

Hi, I have a working UC540 with a 2 port FXO VIC card. I have it connected to a UK BT phone line but the lines are quite noisy and voice conversation sound is feint.I am hoping that someone can recommend the best settings for General, Timers and Audi...

Hi,I'm configuring an office voip system and they have an SPA232D device. They have a PSTN phone line and Cisco IP phone 303. I'm using asterisk sip proxy for the phones and want to route all incoming pstn call to a Cisco IP phone.For the outgoing ca...

Hi,I ran into this few times and wonder how the ATA looses its codec list (I assume that it is indeed an issue with Codecs).The user goes offhook and no dialtone is played but rather the fast-busy tone (the one you get if you are offhook for too long...

Hi,I am looking at ways to test audio quality when a customer reports audio issue. The PBX can echo audio and I would like to see if the ATA could do the same so that I could originate a tone from the PBX to an ATA in loopback mode so I can listen to...

I have now been trying for days to get UC540 to actually answer incoming calls via FXO port without success.The phones ring (blast group) but when picked up the phones still rings ??????I am also unable to make calls, as soon as I finish dialing the ...

I have a SPA504G configured as an extension mobility but I need to add a SPA500S console to it.The problem is that when I choose the extension mobility with SPA500S, there's only 1 line instead of the 4 line + 32 buttonshow can I do it ??

Good morning all -I have my UC320 setup for a small law firm.  I have all calls in normal business hours transfer to an automatic call service (help desk/reception).  Once they receive the call they then forward it to the attorney in which they want ...

HI,I am currently using a UC540W and have it setup to ring the Blast group and then transfer to Voice Mail.Sip Provider is VoIP-UnlimitedI have configured the prefered codec to G729r8, and allowed transcoding.   Everything was working well untill, I ...

Hi,I'm looking for an astuce to configure a SPA500S button module on a SPA 508G IP Phone where we use Extension Mobility.I need to configure the 32 buttom to be either available on logout profile and with the user profile.What is the good procedure b...

Hello, I have a IP PHONE SPA942 and the menu in English, you can have the menu in Italian. how do you? thanks