Voice Systems and Accessories - Small Business

Im an owner of a SPA922 and I have tried everything to reset this phone to its factory default but it persists with the Passwords.  I have done the following:  1.  Tried going to the phones Display and do a factory reset, password requiered, 2. I tri...

I have a system with UC320W and SPA8800 it is possible to use specific FXO port to specific number?example0XXX XXXX use SIP VOIP Provider, FXO1 , FXO2 , etc..etc.. sequentially03XXX XXX use only FXO8 (latest of SPA8800) --- this is the mobile phone p...

Hi:   Is Cisco working to provide mobility solucion with the UC300 like Cisco Call Connect, Mobile Connect for iphone,  Android solutions, etc.?Regards,Diego.

What is the best/recommend device to bring active dual WAN connections into a UC520 environment? Our environment is pretty basic but we do have a few teleworker phones (both IPsec and SSL).I did find an article on how to configure one of the switch p...

Hi,ı need UC560 CUE versiyon 7.1.3 Tr language packed for UC560. I have UC520 TR language but it didnt work at UC560. How can find this file?thanks

Hello,I just installed a UC320 (latest release firmware) and we can not dial any number that begins with 0.  We had to use the UK location as Libya is not listed.  The steps are:1- dial 0 to get outside line2- as soon as we dial 0 (the number is 091-...

HelloI lost my password to get into my UC540 using CCA.I used password recovery that the ISR uses, and I am now able to console into the device and am able to get into enable/privileged mode.But when I copy the default factory config from flash to th...

Is there a way to stop the focus changing to another line/button that starts ringing while you are on a call?ie:Im on a call on button one/line one that I'm about to transfera second call comes in on button two/line 1     Focus changes to "Answer   D...

When reading the documentation for the SPA525G2 phones, it states that when enabling DnD, the call will go straight to voicemail if you have voicemail on the system ? My problem is that, the call acts the same as a normal incoming call, just doesn't ...

Hey guys,Working on a fax over SIP trunk config and was wondering if anybody else has had any success?  I am using NexVortex as my SIP Trunk provider, and have voice working in both directions on G.729r8 and G.711ulaw.I (currently) cannot get incomin...

With Skype for SIP's requirement to dial full international format numbers, I need some help in converting my local area codes to full international dialling codes automatically, so I don't have to dial extra numbers for local calls.Essentially I nee...