Hallo I have a problem with inbound calls since my phone provider changed some settings in their phone system.Outbound calls will work without problems. On the inbound calls I can see with the syslog messages that I receive the request, but the SPA90...
Helloi have UC520 with cp7945 ip phonedisplaying the time on the uc520 "show clock" is 1 hour ahead of the cp7945this started the 1st week of October the clock on the phones changed i waited till today so the timezone changes but the phones did notca...
Hi!CCA went into confusion because I dared to order as I would like the buttons of telephone!In practice, on the telephone with the extension 205 I put the buttons 1 to 4 to 'monitor', respectively, for the extension 201, 202, 203, 204 and then on th...
Hi All,I am hoping someone can clear this up for me! We have recently installed a UC560 for a client and are looking to get the call connector up and working for them. However we seem to be being told different things by different people. Even a call...
Hi,Since I changed my SIP provider, I have following problem :When I get a call from a external SIP line and take them on hold,the the caller will here the message on hold from my SIP provider and not my MoH configured in my SPA9000.When I take an in...
I am trying to get a SPA525G phone operating from a remote location through a VPN tunnel to the central site where there is a UC540. I have a tunnel built between the two sites and can ping the UC540 IP address through the tunnel from the remote sit...
I have a customer with a uc540 running 8.04. I recently updated cca to 2.2(5). They are still having problems faxing out. they are using sip only.They have a high failure rate on outgoing faxes.The analog ports have been reconfigured before. the code...
I have multiple phones experienceing the same issue using FW 7.4.6. The audio on the bluetooth seems to stop working as soon as someone uses the speakerphone while the Bluetooth is paired. If a user attempts to make a call with the bluetooth after...
Hi,if i have a defective UC560 and need a replacement unit, how will i transfer IP licence from the old to the new system.If my custommer migrate from a UC540 to a UC560, can i transfer IP licence from the old to the new systemthanks
HelloI have a UC-560 works well with the CUE 7.1.3IOS version: boot system flash-UC500-mz.150-advipservicesk9 1.XACurrently my system language is English (U.S.)But I want to change language of the voicemail (only) in FrenchI already downloaded the ...
Hello,My provider offers a Speedtouch 780WL (locked) as CPE which provides two FXS ports. I wanted to use a software based PBX so I bought a couple of SPA 3102 Gateways. After a little experimenting, I found that Norway's disconnect tone pattern (as ...
Hi, We recently acquired a UC560 and different phone models: SPA501G, SPA502G, SPA508, SPA525.One of the announced features is the possibility of web administration from any web browser. In order to do that, every document refers to http://phone.IP.a...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: