Voice Systems and Accessories - Small Business

Hi,First, excuse me for my bad english, i do my best.I try to make my SPA502G in French, i install a tftp server and it work well, but SPA502G still in english.I use this command: serv=tftp://<tftp_server_addr>/;d0=English-US;x0=spa525_EN_7_2_5.xml;d...

Hello,I am trying to configure an UC520 using the CCA2.1I have downloaded the locale files as indicated by the "View Localization Instructions", and when I try to use the locale files in the Telephony Setup Wizard I don't find it. I have a reinstalle...

I'm looking to upgrade my UC 520s. Which versions of the CCA and upgrade package has been the most trouble-free so far? I greatly appreciate any insight into this; I understand any experience in upgrading the 500 series is hard-won knowledge :)Thanks...

Hey guys,Is there a full depth rackmount solution for the ESW switches?  In our particular environment, having a set of rear rails would be very beneficial.  Thanks in advance,Seth

The location where we are plugging in the SPA525G has a UC500.  We want the SPA525G to connect to a remote UC500 using the SSL VPN client.   Is there a way to make it not connect to the local UC500?

Does anyone have screen shot of call connector client and server running in MS Outlook. Please see the attached file . I need to find out if the presence information is always displayed as in the attached file.Thank youDarrell Roaden

Hi,at our servicedesk we have some customers who getting problems to run ATAs under UC500 Release 8.0 with 15.0XA IOS. the debug voip ccapi in out never shows the called number, so I think the ATA do not understand the dtmf tones from the analog phon...

Hi,We have just bought 4 SPA504G phones to test before we buy 20 more...We have managed to provision and update the software in them using TFTP.There is just one thing that puzzels us, and that is the call pickup feature.We are using Asterisk 1.6.2.6...

It seems that I have a genuine problem with this ATA devices:When I connect an old/ordinary wired analong handset (telephone) to it, dialing seems to be working fine.But - when i connect a Siemens Gigaset, Panasonic or some other handset, the ATA ret...

Hi CommunityI use the SPA 9000 in a personal environment and would like to have a directory where all numbers are saved and visible on all phones, so the phone in my flat should have the same numbers as the phone in the office which is on the same SP...

Simple question that I don't know the answer to;Can I do PAT on the UC500 if it is only getting it's IP via DHCP from the ISP?The client wants to pass traffic inside but they only have 1 DHCP address and I have only done this with statics.Thanks in a...

I have a SPA9000 and a SPA400 connected behind a WRT54G.  Currently only one IP phone is in use and that is a WIP310.  The SPA9000 is running software version 6.1.5.  The SPA400 is running software version 1.1.2.2 and the phone is running software ve...