VPN

Hi !I am trying to setup a site-to-site VPN from a C7613 (122-33.SRB1.bin) to another Cisco device - using the following commands.I am sending traffic (which is configured in the ACL) - but no VPN is triggered.I got failures like " No peer struct to ...

Have an Ironport behind an ASA, the ASA is configured for WCCP on the inside interface and the Ironport does web filtering.Have some remote sites which have 2811's connecting to the ASA over an ipsec LAN2LAN vpn.The 2811's have a T1 to the internet, ...

When using a PIX device one can setup a dynamic LAN-to-LAN VPN without specifying the IP of the remote router. Is there a way to do this with an IOS router?Thanks,Diego

Hey folks. I was just wondering how much of a difference is normal when using IPSec and GRE-Tunnels. I am new to VPN's, but it seems we have a client that can download files off the internet with ease, but when downloading a 20Mb file off of our comp...

We have several remote sites that connect back to our MPLS network over VPN tunnels. All the remote sites have DSL connections.I need to gauge the speed of the DSL connection to determine whether the site should be upgraded to a T1 from a true servic...

Please can i would like to translate an external subnet to an internal IP on asa and also create a VPN using this interesting traffic.Is the command 'global (inside)' possible?

I have two routers set up with a VPn between them.10.9.1.0/25 --Router--- VPN 10.1.0.0/24---Router 10.200.1.6I need my multicast to travel both ways. 239.255.5.1:8500.I have no idea where to start. Please help.Routers are 2811 with 16 switch modules.

We have one of the spoke sites which is having a VPN connection to the Hub Site. It has Crypto IPSEC tunnel configured. The problem is when the internet connection goes down from ISP side, and when it come up the IPSEC tunnel is not able to re-initia...

This is a good one. We had two network connected devices, a printer and a sort of scanning pedestal. The printer seemed to work fine, however the pedestal, although pulling a DHCP address successfully, had no network connectivity, ipconfig /renew did...

How can I specify different Ip adresse in function of the remote caller.I have a interface carte Wic-2Am in a central routeur.Six remote office have to connect to the central office with PC and analog modem, and I need to associate them different acc...

Hi - I have a ASA 5520 that I just put in. I have it set up for remote access VPN. My clents can connect to the VPN, get and address from the VPN pool, and authenticate against my AD server and get logged in, but then there seems to be no routing t...

Hello - I have seen a few other threads on this issue, but can't seem to fix mine. I have a PIX 506e. My VPN clients can connect, they get a DHCP address from our internal server no problem. But the clients can not ping me or anything else on the LAN...

I am deploying AS5350XM on my client. There is a 4 E1 PRI card installed in it. I need to configure the access server for remnote users who are dialing through ISDN. BRI card installed on remote routers. kindly help me to configure access server and ...

i am getting the following error in my AS5300 access serverASSERTION FAILED: file "../as/if_as_pm7366.c", line 1296ASSERTION FAILED: file "../as/if_as_pm7366.c", line 149running ver is c5300-i-mz.123-26.bin