VPN

All-I have seen a number of posts and searched a number of sites looking for a solution for the 442 error.I am using Version 4.8.01.0590 as this is the only supported (and downloadable) version by my network admins. At least 90% of the time, I type i...

hello...need to download vpn to connect to a client...is there free software from cisco to do this?

First, I'm not Bilingual so excuse my English.Dear Sirs, When you achieve IPSec-VPN with Cat65, is VPNSM necessary?Can you achieve it only with IOS (Advanced Security) ?Cisco IPSec VPN Services Module（VPNSM）Best regards,

Can someone please look at my config and tell me what's wrong with it because i can't figure it. I have been trying to create a site to site vpn without any luck. However, i have been successfully created a vpn for my clients.Thanks in advance!!

I have two 2800 routers and need to set up a site-to-site VPN between them but both use dynamic IP's. Can I use dynamic DNS functionality to make this work? Will I still use 'ip address' as identity?Any problems doing this design?Thank you

All help is appreciated....Here's the situation.* 2811 Router running IOS 12.4(13b)* VPN Client v 5.0.00.0340 on Win Xp/SP2 - Firewall is OFF* VPN using UDP (transparent) running great!* Want to enable VPN using TCP 10000.* ACL ALLOWED. UDP 62515, TC...

Dear, I need to knw the WEB-Based GUI avialble for the following modules in 6513.IDSMAnomaly detection moduleSSLVPNWEBVPNThanks in advanceswami

Hello. I am trying to access my cisco 831 behind another vendor's hardware firewall for VPN services. I have the VPN enabled on the inside interface. I am not using the outside interface at all. I basically want to use this device just for VPN servic...

Hello,I'm having a ISDN problem that the L2 is not activated, but the link is able to dial-out and recieving the call by phone. I did some debug, but the router seems to only recieve something from ISDN switch, but never send out any.Please see some ...

Hi, i have establised site-to-site vpn, Cisco Call Manager is in HQ, Location-1 & Location-2 are connected HQ via VPN, each locationz has Cisco IP Phone & it is pointing to the same Cisco Call Manager which means all calls are registered in the Cis...

How ICMP Time stamps can be stopped on Cisco Routers ?Any link on cisco.com is appreciated.Thanks in advanceSubodh

I want to use the nm-4a/s in the 2600 router to connect to serval cisco device using the console port. but what type of cabel should be use in nm-4a/s 2600 to other cisco device console port

Hi All, Scenario is like, i have 2 remote locations for which there is a lease line between then and also have the Internet Link at each location. Connectivity is like LAN->FW->Router--->Router->FW->LANInternet link is terminating on ASA FW. Requir...

I have a customer whom has purchased two 5510 ASA boxes to replace the 2 legacy PIX 515's in their Production Data Center.While testing today during a maintenance window, we unplugged our Primary box, but the Failover did not work.I have performed mo...

I'm trying to configure a VPN client on a Network but I'm not sure which ports to open on the company's Firewall. Any suggestions?