VPN

I would like to setup the following case for me to do some testing. How do I simulate internet in the lab enviroment between 2 PIX?Can I use one router to similate as internet between 2 PIX? HOw?Or I need more three routers in order to simulate? http...

I've configured the router as Easy VPN Server and can conect to router from other internet host using Cisco VPN Client.I can ping from the VPN Client to the router or any host.However I can' file share from the networks.Since I'm doing this as practi...

I've installed VPN Client 4.8.01.0300 on my home PC and receiving this message when attempting to connect to my office network:Secure VPN connection terminated locally by clientReason 442: Failed to enable virtual adapterAny suggestions?

I'm trying to setup a vpn connection between a microsoft windows 2003 server that is behind a linksys wireless router and a cisco 1811w. Both sites have static IPs. I'm new to cisco and thoroughly confused! I'd be totally lost without the SDM! I...

Hello I need to understand something about Cisco Security Server Agent.I need to run CiscoWorks with the VMS module? How to be pushed the agents to the servers using CiscoWorks Management Centre for CSA? I have all the licenses.But the steps to follo...

If ASA supports internal RSA SecurID authentication will you suggest using an external RSA server ? Pls clarify. TIA.

Recently, we've been experiencing a number of connectivity problems with our ADSL connected remote sites.Our set-up uses a Cisco 837 at the remote site, with an IPSEC tunnel built terminating on our PIX515E at our Head Office.At the remote sites, we ...

Hello all, How can I configure a vpn to a pix 501 to prompt the user for a username and password? I am not using a RADIUS or TACACS+ server to provide AAA. I just simply want to create users on the PIX, set a password on the PIX and then have them en...

Is u-turning VPN traffic between sites or remote access clients possible when traffic terminates on the same interface.Cisco Router 827 IOS 12.3(18)

Is there a way to initiate the VPN tunnel from within the pix?

Hi,Soho91 on one side, VPN client on the other side.I would like to configure my router to give an IP to the client in the same subnet as the inside router 's interface (doing so, no static route would be necessary on my servers to answer the client)...

Dear All, I have ADSL connection PPPOE but virtual-access2 interface up down. BURGAN-TEC#show interfaces virtual-access 1 Virtual-Access1 is up, line protocol is up Hardware is Virtual Access interface MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,...