VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

I am having users lose their dial-up connection after only being connected for 2 to 10 minuntes at a time. This is happening sporadically and while some users on getting connecting and is not have any problems. I usually will reboot the device and th...

ekeen by Level 1
  • 331 Views
  • 3 replies
  • 0 Helpful votes

I have been struggling for some time now trying to get my 2511 to connect through the octal cable to my other devices. All I get is trying router1....open, but I get no access to the devices on the other side of the connection. Please help.....I h...

Hi there.Having deployed a WebVPN SSL method for a customer to access internal mail from say a Web Cafe, a WebVPN login page is displayed, when accessing the outside IP address of the Concentrator.The company's logo is displayed on the login screen.T...

My company primary pix firewall droping sessions (Not working). We took out the primary Pix and let the Secondary to handle the traffics. After ten minutes the secondary also stop working. (drops sessions). What could cause these two pix firewalls to...

I tried doing the upgrade. After TFTPing the image all the Pix does is:Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar 2 22:59:20 PST 2000Platform PIX-515Flash=i28F640J5 @ 0x300Use BREAK or ESC to interrupt flash boot.Use SPACE to begin flash boot ...

azaltsman by Level 1
  • 222 Views
  • 1 replies
  • 0 Helpful votes

Hello, Is it possible for a user to choose wheather to accept callback & continoue with server calling the user back, or to cancel callback and continue to be hooked on the network with user initiated call. For instance, when dialing from windows dia...

smitrovic by Level 1
  • 232 Views
  • 1 replies
  • 0 Helpful votes

Hi ZulfikarWe are using rlm protocol betwen sc2000 and cisco as5350. Especially when we terminate huge calls on gateways all outgoing B-channels are turned to "proposed state".Some similar bugs are already defined for different ios releases in cisco ...

cuneym by Level 1
  • 273 Views
  • 1 replies
  • 0 Helpful votes

I am trying to setup a IPSec hub at a colo center with multiple locations. The colo center has IOS 12.3 and all remote sites has 12.2. Most of the remote sites are on DHCP. Due to the hardware, 12.3 is not possible and DMVPN is not feasible. What I h...

zhenxu_zj by Level 1
  • 403 Views
  • 1 replies
  • 0 Helpful votes

Hi,that's the PIX 501 configuration:PIX Version 6.3(5) interface ethernet0 auto interface ethernet1 100full nameif ethernet0 outside security0 nameif ethernet1 inside security100 enable password xxxxpasswd xxxxhostname PIX-501-10 domain-name mvi.loca...

I have an EZ vpn set-up between a Pix501 (Server) and an 857 isr (remote) The remote client is set in network extension mode and the connection is made and works well for approx 30 seconds and then fails. It comes up again after about the same time. ...

mbluemel by Level 1
  • 281 Views
  • 1 replies
  • 0 Helpful votes