Hello, good afternoon, before anything, I want to request excuses by my bad english. I want to ask if it is possible somewhere to be watched the equipment that supports MPLS and that IOS versions support MPLS too.Thanks
Hi : I am looking for the overhead of running VoIP over VPN.Looking for G729r8 codec with 20 ms voice payload. would appreciate the breakout on the packet overhead.thank you
Is the listed below Hardware compatible/interoperable with the New IPSec VPN SPA Card for 7600 (http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a00804d35a6.html)?- 8 port 1000mb GBIC Enhan...
With a site-to-site VPN connection between two Cisco 837s, is there a way that I can configure the IPSEC tunnel to be torn down after a period of inactivity and then the tunnel is built again when further traffic is passed?
HelloHere is my pb : a Microsoft PC connects trough the PSTN to the router (via the aux port). The PPP connection succeeds.Then, we establish the VPN tunnel with the same router (using Cisco VPN Client). The tunnel is established successfully.After t...
Hi,I have a cisco 2610XM that is used as terminal server. I would like to create a remote access through the PSTN network using the “WAN Interface Card - One Port Analog Modem”. From the router side the interface is RJ-11 and from PBX side the inter...
Hi,I have a 2621 with a WIC 1B S/T card and a 2811 with a WIC 1B S/T V3 cardI have connected the two ports with an ethernet cable and configured the 2 Interfaces but I can't ping neither of the interfaces......is this because I don't have a "proper" ...
Hi,I am really stuck on this one. I want to configure a VPN between 3 pix 515 devices. PixA will connect to PixB and PixC, but pixB and PixC will not connect directly.I have successfully created the VPN between PixA and PixB. I am now trying to confi...
Dear all,I have a problem with a vpn to vpn config, everthing works fine with the vpn and internet access, including static nat to our web and smtp server, however, when trying to access the web or smtp server over the vpn the traffic will not go. i ...
Hi Folks...Actually I have to design a network with one data center and 16 different locations connected to data center . Data center is in delhi and 16 remote sites are spread all over India. So which technology I will use to support the infrastuctu...
I seem to be the first user of every product I install. My IT department had me try to install Cisco VPN on my home XP system. It did not install, it hung on installation. It will not uninstall either. Attempting to install Zone Alarm crashes my pc.T...
Hi everyone, I would like to configure SSL VPN on our VPN Concentrator. I have got this working with username/password combination however i would like to get this working using certificates. Preferably i would like the user to have a user certifi...
Hi,using the document "QoS Solutions for PPPoE and DSL Environments" as a reference I'm trying to implement Quality of Service for a DSL connection via the ATM interface on a 2821 router.So I apply the service-policy under ATM VC configuration mode (...
Can i use the 3845 as RAS if i installed the (accept calls) VWIC2-2MFT-T1/E12-Port 2nd Gen Multiflex Trunk Voice/WAN Int. Card - T1/E1or NM-1CE1T1-PRI 1-Port Channelized E1/T1/ISDN-PRI Network Moduleand what is the difference between the two Cards?
