VPN

hi I have problem . i m uploading IOS via Ronmon but error are as follow. Frist status is ::: System Bootstrap, Version 12.0(2)XD1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. TAC:Home:SW:IOS:Specials for info AS...

Have successfully connected with VPN client to company network and logged in and got logon scripts to run. Tried to connect at home and I can't connect to my company network - can't find Windows logon server. I suspect something with Ciscp PN and Li...

HII have a 871 with 2 VLANs. One for company and the other for Family. The company VLAN has vpn access to HQ for files and such.However since Windows XP can use different profiles as the whole family each has their own profile. Since the XP is sittin...

Table 5 of the following link states that the maximum number of simultaneous VPN tunnels on a Cisco 830 series router is 10.http://www.cisco.com/en/US/netsol/ns340/ns394/ns171/netbr09186a00801f0a72.html I have a few Cisco 837s configured with MORE th...

I have the VPN Client 4.0.1 installed and try to connect to our corp. network through a WiFi connection at a T-mobile or other hotspot. I have tried with a Netgear card and now with a Linksys WPC54G. Both allow me to connect to the Internet just f...

Hi,can i enable NVI (NAT Virtual Interface ) on IPSec Tunnel Interface and how?Thanks,Ali

Hi there,my question is:Does the concentrator provide source and destination NAT?Thanks

I have a VPN setup for my remote internet users. Right now, they can use vpn to get in my internal private network, but at the same time they lost their internet connection. Is there any way to allow user get in our internal network without losing th...

Hello Guys,I have Insatalled WIC-2AM card in 1721 router.It has detected SCM modem.While trying the Dialin Config scenario it is not detecting the ring.If at all defining the country parameters matters then, we are in saudi arabia and we do not know ...

Hi FolksI have a 1721 running ios (C1700-Y7-M), Version 12.3(8)T5. I can get the shdsl running no problem but cannot get the wic-1am card to connect. I have browsed the cisco site and tried just about every solution I have found but without luck.Here...

Morning everyone, i have a problem...I am trying to setup RDP connections from 3 outside addresses through a firewall to 3 call manager inside addresses. Normally we would do static NATing on the router, to NAT outside straight to inside.In this case...

I am going to setup IPsec connections between head office and branches (around 300).What is the most scalable approach for this Hub-and-spoke configuration ?

i have pix 7.0 .there are pptp server and pptp client on the two side of pix.i know pix 7.0 doesn't support pptp.but if it's also can't let pptp throughtout? how to config pix 7.0 to permit pptp connection through pix.thank you very much.

Hello,I have a pix 506 with multi VPN, but with one, the tunnel is OK but it create multi time and i have the error on the bebug view :ISAMKP (0): received DPD_R_U_THERE from peer FWCSISAMKP (0): DPD_R_U_THERE: received seq_no 296113268 out of range,...

Does anyone can help me with this...???? I using a 2821 router as VPN server for mobile users and LAN2LAN sites I using the next link configuration typehttp://www.cisco.com/en/US/partner/tech/tk583/tk372/technologies_configuration_example09186a00801d...