VPN

1) Is there any way to adjust the "source address" behavior of traffic from the remote side of the IPSEC VPN? It appears to have a source-interface of the interface upon which the IPSEC VPN peer is reachable. This is inevitably going to cause routin...

Hi gentlemen,I'm configuring a 827H router to connect to 640Kbps ADSL SP Tele2 Italia.Before I have had very IOS problems and now I have found a stable IOS.... maybe.The SP router requirement are:- Protocol = PPPoA (1577 RFC Routed)- VPI/VCI = 8/35- ...

I am trying to open up a port to allow net users to sync a ACT database. When I make changes to the firewall and then applyu the changes I get a connection lost error. SDM lost connection to router because of a communication error. Router freezes up,...

When I use my vpn client to connect to a PIX firewall in NAT environment,I can find following error message:1 18:25:00.032 02/22/05 Sev=Warning/2 CVPND/0xA3400015Error with call to IpHlpApi.DLL: DeleteIpForwardEntry, error 872 18:25:00.03...

Dear all,we are using a 3640 for analog dialin. In the router a 2-channel PRI card and two 30-channel digital modems are installed. When dialling in a TCP connection shall be established to a host (depending on DNIS) and the data be exchanged. Sounds...

I am having problems connecting over ADSL using an 857W router in the UK. My provider is Demon. Is anyone else having problems?Config used is below,interface ATM0 no ip address no ip redirects no ip unreachables no ip proxy-arp ip route-cache flow ...

Hi,does anyone know if its possible to use a single CLI command to tftp backup the system config and all the context configs to a server?Doing the system and each context configs separately is a bit of a pain when there’s several of them.Thanks,Chris

We have a vpn tunnel between a pix 501 ver 6.3 and a pix 515 ver 6.3 that works well.I am now trying to move the tunnel from the pix 515 to an other pix 515 ver 7.0, but with no luck.I get the following msgs in the log : 713993: ip=x.x.x.x, header in...

HiOur objective is to have connectivity from two different ISPs for redundancy for inward VPN when remote clients dial-in. it neednot be automatic fallback. we will create two connection entries in the user's client. some users will be asked to conne...

Using an ASA5520 device, I have setup VPN on that device. It doles out IP addresses from a pool. There is 1 PC that will VPN into the network and I need to have that PC have the same IP address every time. Is there a way to DHCPC to clients, yet h...

On cisco AS5300 Access server i ve configured isdn users who connects using ISDN modem.But my few users have purchased cisco 804 router(instead of ISDN modem) what configuration should i make on 804 router, without changing any configuration on AS530...

Is there a way to restrict or log a remote access client to a matching pair of mac address and user/password login?I want to be able to track all the remote access vpn clients using both the mac and the username/ password used. I also need to track w...