Hello,Is it possible to enforce the connection timeouts on a vpn client with full time connections to upodate servers like MS Update, ZoneAlarm update, etc.?Thanks!
Hi.Our company currently has a VPN 3015 concetrator, running IOS 4.01. From what we have been able to figure out, there is a 100 user combined user&group limit. Is this a limitation of the IOS or of the concentrator itself. Any workarounds for this?T...
I have a 3640 with NM-8BRI and 6MICA-MDM and everything is working fine. ISDN DDR, Async Dialin, Async Dialout.I'd like to add ISDN Dilaout for our users, I've tried setting connecting with Hyperterminal, setting ATS29=8ATDI 034343443344I am using Di...
I am not sure if this is a complex or simple question. Currently looking to setup approximately 20 remote sites. Each will connect to a Frame Relay cloud as the primary connection back to 2 data centers. The 2 data center will have PVCs from the F...
I have a VPN Client 3002 at a remote office that keeps disconncecting every so often. Here is what I see in the log on our Concentrator:-----------------------------------------------------29963 01/04/2005 11:37:30.390 SEV=5 IKE/50 RPT=227 64.179.xx...
I have a Cisco 804 in my home office that I have had in service for over 1.5 years now. Recently I've started to experience problems that manifest themselves in various ways such as failure to resolve host names and timeouts attempting to connect to...
Good Day,Can a VPN 3005 have multiple ip addresses on an external interface?I was hoping to use it in an environment that has 2 ADSL connections to an internet provider. For the sake of the exercise we could call them router1 and router2.We have som...
is there a command to over write or force the IP address that is being negotiated during IPCP. The problem is we have 3 lns which allocate the dynamic address but when the user has statically configured or cached previously assigned IP, it uses that ...
We're attempting to set up a tunnel to allow http traffic between two LANs via an IPSEC tunnel. Unfortunately, the tunnel only comes up when I select "network autodiscovery" routing under the lan-to-lan connection. I would prefer to simply use netwo...
Hi,I use a 2610 router as ras router and I met with the following problem:When I ping this router with bigger packets, the speed seems OK. The speed of modem connection is 33600.When I use the telnet or any tcp, the speed dramatically decreases.Here ...
Hi folks,our internet goes doem randomly, we installed a sinffer on the network and got to know,around 8 machines sending a lot of multiast packets destined to 224.0.0.103, MDAP uses the said address on port 3235, will it be wise to blindly close the...
Hello and thank you in advance. I am using DMVPN to interconnect my central office (router 3725) with the offices of my agents (router 1721) and I am interested in filtering the traffic coming from the tunnels of my agents. I cannot use the ACL o...
