VPN

Hi I have a 1702 route on the branch office and want to use vpn to access main office with PIX. Following is log view message with Cisco client 1.1 on the windows 98:04:10:24.040 atmel - Initiating IKE Phase 1 04:10:24.150 atmel - SENDING>>>> ISAKMP...

I would like to know what all features can be done using VPN and also how to configure a VPN .

I am running VPN 3015 Concetrator - are there clients for Solaris and Linus available?

Does anyone have a sample config to allow roaming access for this client to the PIX?

I have a VPN Concentrator 3005 that was working great with Win2K clients and PPTP, but will not work at all with WinXP clients. I am running 2.5.2 on the 3005, so is it the software version that needs to be upgraded? Any help would be greatly appre...

I have setup IPSec between two routers,and have made debug crypto isakmp,debug crypto ipsec and debug engine commands enabled on both routers. When I use an extended ping from the source router internal interface to the Peer router internal interface...

I am just starting to investigate establishing a VPN using satellite connections. I have heard that Cisco routers will not work in this situation. If anyone has any feedback on this particular issue or the topic in general, I would appreciate your ...

Does the IPSec through NAT mode work when using the VPN Client (ver 3.x) into a PIX running ver 6.x?

Is it possible to have routing between the spoke-sites in a hub-and-spoke VPN, or do I need to set up a fully meshed VPN? I'm using IOS routers.

Is it possible to realize VPN configuration between PC client with W2K (without VPN Client)and a Cisco router 1720 with IOS Firewall IPSec 3DES ?Thanks in advancedBy

hi,we've got a vpn-tunnel established between two 2621 Routers and have the AIM/BP Encryption Card installed. It work's, but the Performance is not quite what we expected. We've got Windows 2000 and Windows NT Servers on one tunnel-end, and the Perfo...

Is there a Cisco client for Windows XP, beta or otherwise?

For secure transmission of http traffic is SSL adequate and secure verse implementing an IPSEC VPN.

Can I create a site to site tunnel between c2621 and c5300 router. What software feature set is required to achieve this?

We are considering several options to connect to our office in India. One of the options is a VPN lan to lan connection. It looks pretty straight forward to set up but I am concerned that we may have problems on the India end. Are there any specia...