VPN

We have about ~110 Cisco Anyconnect clients and management vpn configured + anyconnect cisco umbrella.Works fine for 99% of them.For some we see the randomly following happening: (especially on newer machines)- user tunnel connected.- user disconnect...

I am currently using Cisco AnyConnect Secure Mobility Client version 4.10 on Windows 11. I need to connect to multiple VPNs at different times and would like to have a saved configuration for each VPN so that I can easily choose the desired connectio...

Dear Community, I have an ASA firewall connected to another firewall with: One direct L2 connection between the 2 firewallsOne IPSEC VPN between the 2 firewalls with a few flow still passing through it I’d like to take the flows outside of the IPSEC ...

Hello,so with customer we have created S2S tunnel to have access some lab environment. They asked us to create NAT and this NAT they will allow through tunnel. So I created NAT from our Anyconnect VPN addresses. Lets say IP is 10.10.0.0/17 of our any...

Hello,I am using Cisco AnyConnect for VPN solution. We are split tunneling and excluding what we do NOT want to go over the VPN. We are doing this multiple ways including via an ACL with CIDR blocks and also with a custom attribute with domain names....

Hello,When I try to connect with AnyConnect, I receive the notification "Could not connect to server. Please verify Internet connectivity and server address". Internet connection works fine.I tried reinstalling the program, deleting the XML profile, ...

We have two FTD 1140ns (7.2.5)in an HA enviroment managed by a FMCV(7.2.5.1). In our vpn setup we have two connection profiles that both run with DUO SSO authentication setups that are the same. One connection profile works with one IP pool and works...

We are working on connecting AWS Site to Site VPN and Cisco Meraki.At this time, the configuration resources are as follows.AWS Site-to-Site VPNLocal IPv4 Network CIDR => 172.31.10.0/24 {Meraki}Remote IPv4 Network CIDR => 10.10.0.0/16 {AWS VPC}check ...

Hi Community, We have a newly established IKEV 1 tunnel from Cisco ASA to AWS. This tunnel is currently at up state but the traffic is not passing through the tunnel. When we enter the show command "show crypto ipsec sa peer X.X.X.X" output have enca...

Hi all,We are planning to replace ASA 5525 with virtualized ASA on Firepower. While checking the configuration which we restored from our running ASA(which contains a folder named VPNPresharedKeys with a single file for each VPN profile), we noticed ...