Wireless

Hi Everyone, Can Cisco 9800CL be configured as N+1 for the WLC 3504?Are there any limitation on it? Regards,Deep Bartwal 

Hi All,Please help - Need verification that the WLC 5520 can do SGT in parallel with dynamic VLAN assignment.Cheers, 

At work I've stumbled into this task where I needed to update our virtual WLC from 8.1.133 to 8.10.2.2. However in addition to new APs (9120) there are still APs (2702) in use that are not supported by the new WLC.I've been told to just upload the bu...

Hi All,How user communicate when we implement channel width of 80MHz with AP of 2800 series. Can you please share flow? It helps me defining DCA config implementation

Dear Friends, I have to upgrade IOS in 5520, here my question was how to identify which FUS was installed in the WLC.GUI ----Software Version 8.3.141.0Emergency Image Version 8.1.102.0 -------sh sysinfo Product Version...................................

Hi team,I pulled report from NCS for AP utilization, it gives multiple instance for same AP in AP Client statistics summary. ANy specific reason why its giving multiple instance. We are fine if its give two, becaus eof readio but single AP gives for ...

Hello, We have here only 1 Cisco 5508 WLC catering to 490+ APs (AIR-CAP702W and some AIR-CAP702I) running with software version of 8.0.140.0. These APs are connected to C2960X. I am monitoring these APs from my office. The issue is I am experiencing ...

Hi there,I need some help understanding Meraki offerings that would help me get better WiFi performance and overall network security in my house.Situation is as follows- 2 story standard West USA construction (wood frame, drywall), medium size home w...

Hi, I installed 8.1.122 on a WLC and I see a feature that I can't find any documentation on. Under a RF Profile in the RRM tab there is a feature called High-Speed Roam and a checkbox for HSR mode and Neighbor Timeout Factor. What does this do? I hav...

Hi everyone,I am trying to use 802.11w PMF feature for a 802.1x SSID. When I configure it to "Required", supported clients can connect with AKM: 11w-802.1x and unsupported clients cannot connect at all. This scenario works as expected. But when I do ...

We have had an AIR-AP1572EAC-E-K9 installed by a 3rd party but unsure if the alignment is as true as it could be, I’ve been searching Cisco with no luck on how to make sure that these are aligned as good as they can be. Is there a tool that we can us...

Hello,i have two C9800-40 Controllers, both installed via image (.bin) in bootflash: via install add command. Now i have one who installed in bootflash:, boot system bootflash:packages.conf and the other one in harddisk:, boot system harddisk:package...