Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hello all,facing a strange issue with WiFi network, everything works fine during weekdays and during weekend we get issues with WiFi network.I see AP has been reset by controller for some times.any suggestions what can be checked.
WLC Config Converter (AireOS, IOS-XE) External Link: https://cway.cisco.com/wlc-config-converter/ Goal of this tool is to provide easy config migration between various wireless platforms.One tool can perform following operations: AireOS(2500/3...
Can Meraki WI-Fi 7 or 6E APs perform WIDS/WIPS on the 6 GHz radio? I hear that there is some limitation with this operation. Can someone enlighten me?
I divided a flat network into two VLANs. That really doesn't come into play here and I do understand routing just fine.But... even though printers and TVs are on the same subnet as our corporate PCs, discovery and Casting doesn't work as expected.PCs...
Can Wi-Fi 6E/7 APs perform WIDS/WIPS on 6 GHz. I have heard that WIPS is not possible due to some limitation, but what about WIDS?
What can we do if we have high cnahlle utilization? Below AP operate under channel 6 In this floor i have 5 APs and other 4 APs not use channel 6
Hi community, I have configured a Guest SSID with Local Web Authentication on our 9800 WLC. Initially, users were facing frequent re-login issues. To resolve this, I made the following changes: Increased the init-state timeout to 28800 seconds Enable...
Hello all, I need some advise.I am trying to set up a Guest WLAN on Mobility Express with the ability to authorize guests through a ISE Guest Portal(Sponsored or any other kind).I have ME 8.5.151 and i purposely upgrade it to 8.10.130.But in this ve...
I would like to bring to your attention an observation regarding the link speeds of different access point models connected to our Cisco C9300 PoE+ switch. We currently have three types of APs in operation: C9200 AP – Showing 2500 Mbps on WLC C2800 A...
Until recently, when an access point was operating at less than 1Gbps, it would show up in the "Alerting" in the dashboard. For whatever reason, maybe after the most recent firmware update, if an access point is operating at 100 Mbps or less, it no l...
Is the column of wireless client monitor below can be customized? I need to showing the client devices name where now i only can see the name if we click on each client. Tyr to exporting the data but the device name is not showing.
Wireless firmware versions MR 31.1.7.1 changelogImportant noteWi-Fi 5 Wave 2 MRs support - This version and subsequent MR 31.x.x are only supported on 802.11ax (Wi-Fi 6) and newer MR models. 802.11ac Wave 2 and older products will upgrade to the back...
In the past days ,our APs unexpected reboot (except the AP14 in red frame) , the reason is as below . I checked the log in switches ,only found port donw up event . These 4 APs are connected to 4 different Cisco 2960X switches. AP01 is CW9162 and oth...
I have wrong assigment license for my AP, previously i assign DNA Advantages in the controller and i change to DNA Essential because this is license was purchased. When the AP using DNA Advantages then in the smart account i have insufficient license...
Why ap is blinking red/green 9120ax
