Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Resolved! Error load Profile

Dear Sir/madamI using Wireless LAN Controller 2504 and Access Point 1832.System was set up, but I have this error: Load Profile FailedPlease help me 

Error Profile.png
thbinhvdc by • Visitor
  • 6293 Views
  • 2 replies
  • 0 Helpful votes

hello i have a question please i need your answer  if SSID is brodcast desktop for AP 1815i moblity express  but  they don't have Interent means the AP don't recieve ip address from DHCP !!!?? i need answer about that problem !!

hello i have a question please i need your answer  if SSID is brodcast desktop for AP 1815i moblity express  but  they don't have Interent means the AP don't recieve ip address from DHCP !!!?? i need answer about that problem !!

Tuesday Hello,Recently I try to configure a cisco virtual cisco WLC with clearpass. So I have created a guest SSID and when a client connects to it  he is successfully redirected  to clearpass self signed portal. There the user can self register hims...

Hi,I have a wifi access point (Cisco 1141) that broadcast 2 VLANs (2 & 4). On the VLAN 4 no problem. On the VLAN 2 when a device try to connect to the access point an IP his delivered by the DHCP server but the client can't access to network. It can ...

image.png
jb.ponce by • Frequent Visitor
  • 2353 Views
  • 4 replies
  • 0 Helpful votes

Hi All. We have this strange wifi issue with 802.1x-flexconnect(switch vlan breakout) on vwlc(and wlc 5520) and 2802i everything looks fine, authentication works fine.APs er registered in controller and work fine but often client looses network acces...

dmbnex by • Level 1
  • 1272 Views
  • 2 replies
  • 0 Helpful votes

i found that mobility express access point can act as a controller where other access point can join it , my question is does the other access point need to be lightweight or also ME to join?does all access point need to have the same ME version or l...

baselzind by • Level 7
  • 4668 Views
  • 6 replies
  • 0 Helpful votes

Hi folks,This is my maiden post and I am quite new to Meraki - please be gentle!I am setting up a mesh network with 4 x MR33's and want to setup as follows - 1- a guest SSID, with bandwith limited, going straight out to the web.2- a corporate access ...

RalphtheMac by • Community Member
  • 4026 Views
  • 3 replies
  • 1 Helpful votes
Review Cisco Networking for a $25 gift card