Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
Hi All,I am planning to cover a Mezzanine area which is 300 feet long and 30 feet wide. My plan is to go for one 2800E with AIR-ANT2566P4W-R. However I have doubts regarding if adding one AP with antenna on wall facing other end of wall should be eno...
I've been working on a Cisco 3802i WLC. I am unable to ping the Management IP address of WLC. - I've followed step-by-step instructions from Cisco, how to configure 3802i WLC. - Configured with proper IP address, subnet mask and gateway IP address. -...
Hi all, I'm doing the initial set up of a 3750G WLC through the web GUI (device manager.) I've come to the login splash page for the WLC itself and it's asking for a username and password. I've tried various combinations of admin/admin (which is what...
Since the "forced" upgrade to MR 25.9 firmware, my ESP8266 devices fail to reconnect to Meraki if they disconnect and connect frequently. These devices can enter deep sleep and connect again every few minutes to update their data. If those periods ar...
On the screen of the phone it is saying: registration in progress it has been doing this for a while and I think I am stuk in a loop. This is my phone 7841, I am trying to get SIP firmware on there through my Tftp server but it seems to be stuk in a ...
Hi,I have 3 APs working on a ME environment, the master AP (wlc) and 2 APs associating to the wlc (all ME capable). All working perfectly.Yesterday i try to add two more APs, but i have noticed something when i was booting boths APs (before i have tr...
I'm a volunteer at our local hospice thrift store, working on electronics, testing and preparing for sale. I've worked a lot with domestic wireless networking, but not the pro stuff. We've had one of these access points donated and I'd like to be abl...
Hellol, I have a new AIR-AP1852I-B-K9 and want to add it to the rest of the APs in cisco wirelss controller 2500.I thought there should be a place in web UI to add mac address and that should do everything else.please help. thanks
Hi All. This is is to ask if you had this issue in order to help me with your experience.I was trying to upgrade CT2504 from 8.2.151.0 to 8.3.150.0 but when the copy is finished, either TFTP o SFTP, by CLI or GUI, fails and ends with this message: "F...
HiI'm using an AP 2802e with mobility express 8.8.111, I have a ssid with external web auth using a captive portal (externally hosted).In this portal users introduce their credentials and the radius server response if they are allowed or not.This is ...
Hello, I'm looking to get a trial of the virtual wireless LAN controller. I picked up a Airnet pretty cheap though ebay and thought that I could just download the wireless controller, but as I don't have anything listed in my account I can't. Is the...
Can Cisco Prime run an inventory of WLC Interfaces and WLANs? This may seem like a simple task when looking at a single WLC, but I want an inventory of 100+ controllers with what each WLC has for Interfaces/IP addresses and what WLANs are configured...
Hi, I have been testing different AP's with WLC and facing issues with two of the AP's as they are unable to join the WLC and always showing as unjoined and giving errors. Previously these AP's were configured with Autonomous SW and then i have upgra...
Hi Guys, i am planning to AIR-AP1562E-M external access point, but not sure about Antenna selection. Could you please help me understand for antenna Selection for External Access Point and minimum count for Antenna ? Regards Cisco Champ
I'm a seasoned admin, but I'm bit new to enterprise level wireless networking so please bear with me. I've searched on this topic for quite a while and have not come up with anything. I have a WLC5508 with SmartNET on code 8.5.140.0. I have qty 8 o...
