Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

WLC 5508 ISE - When using single SSID for BYOD from iPhone versions 12.x and onwards you need to apply config network web-auth captive-bypass enable on all your WLC's in order for the iPhone browser to be supported so supresses. That's a problem for ...

Hi all, You may not be able to give a definitive answer on this but my question is about the following vulnerability announcement:https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20190417-wlc-iapp We're running version 8...

CiaranB by • Level 2
  • 782 Views
  • 1 replies
  • 0 Helpful votes

Hello all,I have 3 APs (AIR-CAP3702E-E-K9) in 3 building connected with each other and i want to run VoIP services within buildings , so my question dose it support or it depends on the Switches(VoIP service support)? Regards

I have upgrade Cisco WLC code. Code has been upgraded Successfully but aps are joining yet. From the logs i can see the following.Failed to authorize AP Name HAM03313AP12 with Base Radio MAC 00:2c:c8:82:93:c0. Authorization entry does not exist in AA...

Have any1 being able to use a Z1 to work as an additional Access Point in your networks ?Like you've purchased a Z3 and made the border router and want to leave Z1 just to enhance coverage in other room.

theunfcco by • Level 2
  • 9226 Views
  • 8 replies
  • 0 Helpful votes

I'm starting the path to CCNP Wireless. The test has recently been revamped and like a lot of new Cisco Certification tracks the test comes out before a decent amount of material. What would someone suggest to start this process while there is not a ...

HiI am looking to advertise a number of wireless profiles for an organisation that has a presence on our campus.  I will use our APs to do this and then run Foreign/Anchor set up for each profile so that clients of these profiles break out onto the o...

Hello, On 802.11a/n/ac 5Ghz WLC 5520 configuration, for on of our Cisco 3702E APs, the power is currently configured to 1 (17 dbm ~50 mW) when we are below this AP with a scanner Datalogic FalconX3+, in the status of the scanner it shows 80 mW for tx...

Clem58 by • Level 6
  • 4417 Views
  • 9 replies
  • 0 Helpful votes

Hello!I have a problem with ap AIR-AP1815I-R-K9i have 2 AP and they have same firmwarecisco AIR-AP1815I-R-K9 ARMv7 Processor rev 5 (v7l) with 1015824/668048K bytes of memory.Processor board ID FGL2237B10GAP Running Image : 8.8.120.0Primary Boot Image...

Alex_rt by • Frequent Visitor
  • 11836 Views
  • 27 replies
  • 0 Helpful votes

I have ran these debug commands and below is the output the I recieved.debug mac addr AP MAC ADDRESSdebug capwap event enabledebug capwap errors enabledebug capwap detail enabledebug PM PKI enabledebug DTLS Event Enable  *spamApTask1: Apr 24 13:35:35...

ERIK S by • Level 1
  • 5933 Views
  • 13 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card