Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi all. I'm a bit concerned now, because I by accident discovered that there is a difference between the startup-config and running-config on one of my WLCs. I discovered this when I compared startup-config for two of my WLCs. For instance a co...
Dear Mates, Kindly support me We have cisco access points 2802, But we don't have wireless controller. Must transfer IOS from light weight to mobility express after we transferred and took right configuration and IP ...
Hi, Is it possible convert an air-ap1852i-k9C in a capwap to connect it to a wlc3504? Thanks to all V.
just noticed this one the other day, neither of our mobility engines are syncing with the WLCs.Our setup is:PI 2.1all WLCs are 7.4.121.0MSE3355 - was 7.5.102.101vMSE - was 7.5.102.101 all was fine. We upgraded both MSEs v7.6.120.0, due to the deferra...
We acquired 4 outdoor access point, but when trying to configure them it could not be done since researching comes in mesh mode and we do not have a controller, which I can do to configure them in local autonomous mode Greetings.
Hi, I have AIR-CT5508-50-K9 (50-AP licenses preinstalled) Then I increase licenses to 250 at different times If I buy CON-SNT-CT5508 for the orijinal system. All 300 AP licenses are covered? In the case of RMA, Can I move 250 Ap licenses to new s...
Hello Team,Plz help to fix the issue. There are some barcode scanner facing dropping issue in aruba but in Cisco they are ok. The error is coming in scanner that lost of connection and searching host.
Good morning, I'm having more and more difficulties to find AP models that actually have an ios supporting WDSAll my models are now EoL, and Cisco advice to replace them with 1800/2800 seriesThe fact is these series are dealing with Mobility Express,...
Hello Guys, I have a Cisco router 1941W for my little lab that has an AP801 access point built into it. I want to upgrade the software for my Router and 801AP to a newer version because i got all the time problems with WiFi..... Here is what it is cu...
Hi Team,We are facing issue in our 1000 series lightweight access pointShowing limited connectivity and not able to get the ip address for the associated clients(laptops)pls help on the issueI have attached the debug client command for ur reference.T...
Hi TeamWe are doing Dot1X authentication with Meraki Wireless and ISE. When the client connects using dot1x the authentication success message is sent to ISE however the IP address which it received after authentication is not sent. Now we understand...
Hello, I am trying to Configure SSL for a Cisco Wireless LAN Controller 5508 but when I type the follow command appears error opening input file: OpenSSL> pkcs12 -export -in All-certs.pem -inkey mykey.pem -out All-certs.p12 -clcerts -passin pass:...
I have some access points air-sap1602 and I would like to include them in other access points (air-ap1852) purchased now, is it possible? I'm not using any controller, it's just a few ap Thank you
I have some problems with my vWLC. I created two WLANs. But when I check them in my mobile, the created SSIDs are not showing me. Even I enabled Broadcast SSID they are not showing me.Picture (Capture 6)Picture (capture 7)The other thing is even I co...
