Wireless

I am trying to add this phone as an extension to my pbx. Not sure how to do this, I don't see anywhere I can provision the phone. Is there another device that I need to accomplish this?

we see sometimes on a 3750switchSW_MATM-4-MACFLAP_NOTIF: Host 000b.xxxx.xxxx in vlan 5 is flapping between port Gi2/0/42 and port Po7looking up the MAC we found wifi devices like a pc and handscanner which move to the building thereby changing from A...

Hello Experts,   What will be the Significance of AP group when an AP is already moved to an FlexConnect group?   When an Access Point is moved to a FlexConnect Group, it still continues to get reflected in the AP group. Why is that the case?

Hello, I am a bit confused about the session timeout value  found in Wlan>advanced tab. our setting is set to 1800 which is the default. Our vendor just told us that this could be causing the client disconnect that we are seeing.  I was under the imp...

We have several 5508 controllers and are experiencing similar problems on a few of them. They are working great for any AP that has been active for a while now. The problem is if I add any new AP (2702) or a older factory reset AP (1042). After I con...

Hello I have a controller CISCO 5520 and AP 1832i I want to disable the 2.4Ghz for a professional SSID (automatic handling trolley) I saw that for an SSID we could choose 802.11a but by doing that I can not connect ... If I put on all, I can connect....

Hello,   I'm confused in understanding when Wireless client connects to AP what process it goes first; Authentication or Association? And what occurs in these two processes? What I know is 4-way handshake does occur in Association Process and EAP pro...

i have a 5508 series wlc and i need to install six licenses on it , the problem it is in production . Can i upload all six licenses then reboot? or should i install each license then reboot afterward?

hello,   i have cisco Virtual WLC with one license  i installed another vWLC and i need to migrate the license to the the new vWLC   somebody have a somution please !?  

I cannot connect to the managent website of the AP when i use tagging on the gi0 interface.    If i use a BVI 228 interface for VLAN 228 and give it an IP i cannot access to the Ap.   When i use the BVI 1 interface and give it an Ip i can access the ...

Hello All,   I have two Access Points and I discovered that one of them has the 37540 port open.   1) It is possible to turn if off ? If yes, how? 2) How this affects the AccessPoint clients?   Thank You.