Is there any command to check Sepcific Access point interface 802.11b/g/ , Interface 802.11a/n/ac status from WLC? We can check it from WLC GIU but is there any command to check it from CLI?
Dear All,
The Cisco 1832i datasheet mention "If 802.3af PoE is the source of power, the USB port is disabled".
The power source we used is 803.2af PoE, but the access point seems reload unexpectedly. We change the power source to 802.3at PoE to res...
Hi,
I am crating a ISE sponsor portal for our Guest WiFi infrastructure.
How can I remove the fields highlighted in red in the sponsor portal? ... These used to have things like notification laguage, purpose of visit etc. I have specified these as ...
Dear All,
Please tell me how to setup WDS which can manage the full network like DHCP, Roaming, AP Management etc.
I have worked on WLC but this is my first time with WDS.
Any help will be a greatly appreciated.
Thanks
HOW CAN I CONNECT WIRELESSLY MY THREE CISCO MICROCELL DEVICES TO MY ARRIS WI-FI ENABLED MODEM?
YOUR HELP IN SOLVING THIS PROBLEM FOR ME IS VERY MUCH APPRECIATED.
BEST REGARDS,
HOSS SERRI
Hi everybody
We have a Wireless LAN Controller 5520 with software version 8.1.102.0 and recently we decided to install DTLS license , based on this document
http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn81.html
We have ...
I have a Cisco 2901 Integrated Services Router that has the default IP address of 192.168.0.1 but I am also running a 2nd router that has the same default IP address. How do I change the IP address on my Cisco 2901 Integrated Services Router?
I have a AIR-CAP2602I-E-K9 to play with, I've converted it too Autonomous AP. I want to create three SSID's 1x for GUEST Access on VLAN23 1x for MOBILE (phones etc, using WPA2-Enterprise) 1x for LAPTOPS (WPA2-Perosnal) I cannot see anywhere on thi...
Hi,
Is any way to authenticate Guests once they comes to our cooperate network.
IT Administrator need to get a message and he will authenticate them with out web auth
Thanks,
