Wireless

Hi,   How many access points need to consider for 120m W x 25m B x 12m Height by using CISCO AIR-CAP3702E-E-K9 Wireless access point     Thanks Vijay

I have two AIR-AP18502i mobility express. I am trying to Redundant or primary and secondary controller. I used the command is below   config ap next-preferred-master <Cisco AP> Check this command to very-fie  show ap next-preferred-master It working ...

Hi Folks   I am getting problem in wired dot1x in cisco anyconnect. The port goes unauthorised after 1 hr automatically. As per DART logs, connection duration timer expired is what i got.   I am not able to track the dot1x logs from switch as well no...

Team,   We received New Cisco IP Phones 8821,  how can i configured New Wlan SSID for this phones to use  802.1x Authentication.   Regards Irshad    

my dear    i need your help to link for download best IOS for  AIR-WLC520-K9   regards  

Hi, A customer would like to use AP2600 and AP2700 running autonomous mode in the same building.  My concern is that roaming will not work correctly.  Would they need a WLC for the AP2600 and AP2700 to work together?

Hello Experts, Need your suggestion, though I have gone through some documents the solution does not work as per my requirement as below. I want to use aironet 1200 APs to create a mesh network. This model isn't supported for creating a mesh network ...

I have noticed recently that when our AP is rebooting and priming the LED pattern is as follows: solid Amber solid Green cycle Red-Amber-Green shortly blink Red cycle Red-Amber-Green blink Green solid Green (clients logged in) I am concerned about th...

Hello,   We are trying to do a site survey to better enhance our wifi coverage, however, the Field Engineer will use Air magnet tool in his survey, how Can I  make a predictive site survey using this raw file? however I don't have Dongle or the Adapt...

Hello,   I would like to know if this is possible to configure an access point over console to flexconnect mode, and configure the IP address and native VLAN , without having it connected to a WLC ?   that's to say, connect an AP with power cable, co...

Hi Guys, a client has an existing wlan setup where in the WLC is on a different location from the APs each having different routing domains now to establish communication between the 2 static routes are used and their next hops is located on a differ...

Hi there! We got different sites with receptionists using their own lobby user for guest account creation on our anchor wlcs (v8.3.140) . We would like to run a report where we can see the guest account creation of all lobby users e.g. in December la...