Wireless

Anyone able to provide me with some tips to get Cisco Prime Infrastructure to give channel utilization reports?  (Bad CCI here)   Is there also a way to pull the minimum basic rates being used by all of the APs across various controllers or does that...

Hi; We've just replaced our all ap (app 80 piece) in network environment. Old ones is 1242ag.  After replaced we started to get bad voice quality. Sometimes voice is interrupt during call and after 1-2 seconds it comes back. We configured wlc setting...

Can anyone assist. im setting up a aironet 2802-E ap as a standalone unit i.e its not going to join WLC. im new to the wireless environment but have done much research, in order for me to use this ap as a standalone unit, i need to convert to mobilit...

Hello everyone,   i got 8 cisco ap's from our companies it admin he dosen't need anymore...   Is there an easy and low cost way how i could use these ap's for my home network including a working wifi handover.   thanks for any information!   best reg...

Hi,   I am wondering if it is possible to produce a report that shows the average users per SSID per WLC? We are using a variety of WLCS: 5508, 4402, 2504's.   Could someone please advise if this can be done?   Many thanks

Hello,   I've setup a SSID that WPA2 with AES along with MAC filtering on ISE to enable our symbol zebra devices to connect to the network but I'd like to make sure of 802.1x machine based authentication so I can make use of Cisco Centralized Key Man...

As documented, we have to search between all joined APs in Prime and then choose one by one and drag it to the correct location in the map. If there are hundreds of maps and thousands of APs, this will take months of configuration.   Is there any fas...

I would like to be able to see client RSSIs in the commonly ascribed simple dBm value, ideally in a table, but I cannot find this in Dashboard. What I do find is a positive value, which is not possible. RSSI by industry convention should yield a valu...

Hi All, Recently I updated the license, and currently showing mismatch of licenses. Please find the output Base AP count license shows 27 AP's supported, however " show license capacity " doesn't show the actual license. AP's are also not joining the...

The SSID I created broadcasts for a few seconds then disappears.  Then there is no way to connect in, and the lights cycle red, green and amber.

Hi all,  as per technote, if we want to configure LAG, 2820i is compatible with few cisco models only (3850/3650) etc.    Why is that so, isnt LAG = LACP?