Wireless

Hello, I have a CMX 10.2 located in a DMZ for External splash screen for guest authentication at a remote location using a Cisco 5508 WLC. after we setup the CMX, the guest can authenticate just fine!!! but now any body can access the web based manag...

Will access points installed at a branch site (different subnet) automatically find our WLC 2504 at our headquarters over the WAN?  The sites are connected via MPLS.  Does CAPWAP automatically jump from one subnet to another over a routed network?

I'm looking at some Cisco WLC configs for a customer and under 2.4GHz settings, 11mb is Mandatory, and 5.5, 6, and 9 are set as Supported.  1 and 2 mbps are disabled.  There is no other Mandatory rate set on the band. Can anyone give me an example of...

I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command. Has anyone noticed this?

Hi all  just small Question about MSE version 10 if i buy it as a virtual can i installed in hyper V or not ? and what is the specification for that ? thanks 

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?

Hi On a WLAN network for one of our customers we only allow APs to connect if they authorise against a AAA radius server using the mac address of the AP ethernet interface as the username and password. Currently we do this using an ACS as the AAA rad...

Hi, Facing issue while configuring 1830 AP in standalone mode. Already did hardware reset, still its searching for controller. Anyone help with the document or guide.

Hi, I have problem here regarding my cisco 1600 aironet AP. It always reboot itself with this command. All AP that connected on this WLC face same issue. My WLC now running 8.1.131.0 software version. The AP connected by using POE. Mon Jul 25 15:54:1...

Hi all, I am getting a continuous stream of messages like the ones below on my 2504 WLC. *webauthRedirect: Jul 22 23:05:25.275: %EMWEB-6-PARSE_ERROR: webauth_redirect.c:1477 parser exited. client mac= 54:ef:92:37:e4:30 bytes parsed = 0 and bytes read...

Hi, Now, i am facing some time zone issues with ISE 2.1. When i create Self-Registered Guest Portal, i can add our time Zone (Yangon). Then i change to Sponsored Guest Portal with my authorization profile, this portal is using default time zone (San ...