Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hi everyone, We have a cisco 4400 series wireless Lan controller with software 4.2.207.0. This controller is been in one of our building and is working for years without any issues. Recently I started noticing that it was responding quite slow but ...
Hi All,I have a WLC 5508 located in our main office. We have remote site around 350ms. latency from the main office.Radius server also located in the Main OfficeOn the remote site 2 APs running in Flex Connect.2 SSIDs - One locally switched / One Cen...
Hello,I need to know if I can use the AIR- ANT24120 antenna on the access point model AIR-CAP1602E-T-K9 ?
I've been asked to set up a point to point wireless bridge (distance 50 metres) with a pair of AIR-LAP1602E-E-K9 access points.Is that possible? I know they're not listed as wireless mesh capable.They need to be controller based as this requires cent...
Resolved! Valid license PI 1.3 to 2.1/2.2
Hey guys!I want to upgrade Prime 1.3 to 2.2At first I go from 1.3.0.20 to 2.1.0.0.87. Make a backup and restore this on the running system 2.1, right?Than I'll go to make a backup from 2.1 and restore it on 2.2, right?Now my question: Do I need a new...
We have 2504 wlc configured with 10 AP (3700/3600).Issue is that internet is disconnect again and again even signal strength is full. When I checked using inSSIDer office tool I found out Unknown Keyword in 802.11 section(You can see in Image). Plea...
Resolved! WLC unable to be added to WCS
I have a new WLC 5508 with 7.4.110 IOS.WCS is 7.0.230 IOSwhile trying to add the WLC to WCS.getting error as attachedFailed to add device to WCS Reason: SNMP operation to Device failed: Sparse table not supported. Verify that the WCS and WLC versions...
Resolved! Upgrade cisco WiSM running in HA mode
Hello everyone, I have to upgrade a VSS (2 chassis 6509 WiSM that are in HA mode) to code 8.0.110.0If I upgrade the active one, the second one will be also upgraded ? Just like for the 5508 models ? Or do I need to break the HA, upgrade both WLCs and...
Hi Cisco Support Community, I am currently notice some issues within my WiFi infrastructure.Our infrastructure is setup with a 8510 WLC high availability cluster (AP SSO) and a 5508 WLC high availability cluster (AP SSO) as mobility anchor within the...
I have a Cisco 2504 with Image 7.4.121.0 and AP 2702I with image 15.3(3)JA, i did a small lab and i connect the ap directly to the POE port on the controller and I did all configuration correct and made the controller a DHCP. However the AP is gettin...
Hello. Someone knows what does it mean this log in the wlc 5508 with 7.5 IOS version: *apfMsConnTask_5: Oct 25 12:07:04.880: #APF-4-RCV_ACTION_FRM_WITH_CODE: apf_80211k.c:643 Received Action frame with code 4 from mobile station 4C:8D:79:CF:9B:53 Be...
The Native VLAN is it the Maintenance VLAN from controller would it always need a value in the native VLAN ? Configuring Neighbor Devices to Support Link AggregationThe controller’s neighbor devices must also be properly configured to support LAG.E...
Hi i am using 5760 wlc and cisco switch 4948 core switch and 2960 access switch .on core switch i create two vlans vlan 10 name mangementvlan 50name clentwhen i am creating SSID in controller via command line and assigning vlan 50the following error ...
Resolved! SP WIFI Eogre
Dear ALL, Please could someone shed some light on the subject Ethernet Over GRE what is the RFC #Where could I find documentation on How to implement such a solution to offload Mobile network to Wifi network with real examplesI tried to use Cisco fea...
After factory defaulting the Cisco 2504 WLC, I go to through the wizard for initial config then log into the web interface and download my 'full' config file to the controller. After the reboot I upload the config file to my PC and compare it to the ...
