Wireless

I've recently upgraded from 8.1.130.0 to 8.2.110.0 (a few days ago). Spontaneously at lunch time today, the active controller rebooted. The switchover reason is "active controller failed", but I can't find anything else to give me an indication as to...

Hello Team, Need help to configure Wireless Network. i have 2702E autonomous - (8unit) with SG300-28port (1 Unit). Requirement :- 1. Multiple SSID with different VLAN on AP. 2. WDS or Repeater mode for WL. Thanks Nipul

Hi Fellows, I'm searching for a solution to disable the Ethernet broadcast setting on the WLC globally and enable it only on a per access point / Vlan basis. Is there any way to achieve this? Maybe through FlexConnect? I was not able to find any rela...

Hi I looked around on the forums wasnt able to find the answer to my question. Can you operate a 3702E without external antennas? 

Hi,   I am currently working on an Aironet SAP 1600 series (or a 2600 series). I use it as a sniffer by enabling the monitor frames command on one of my Dot11Radio interfaces. The endpoint is a PC that is running an HexaDump parser (Wireshark/Omnipee...

Hello, Following issue we have at one of our locations equipped with WLC 2504 (FW: AIR-CT2500-K9-8-0-133-0) & several AIR-CAP3602I-E-K9 During continuous client traffic load like SQL data retrieving, AP drop client. It mean client loose connection to...

Hi Alex, We have a setup with Cisco WLC 2504 and couple Cisco 1600 APs. Most of the clients (PC, Android, iPhone/iPad) are able to connect to the wireless. But, not with the Bosch soundtouch system. However, when soundtouch connect to my home wireles...

Dear Team ,  I have an issue where I have primary WLC 5508 have LPDE image installed and HA controller purchased with Non LPDE image installed. Due to this image mismatch , i am not able to configure HA and i need to inform the image installation in ...

Hello,we have an expected reboot of our active WLC5508 in HA cluster two weeks ago. The standby unit became active and because of Xmas and New Year holidays we found it only yesterday.There is no crash file generated by the controller during reboot. ...

I am facing issue with AP1532E joining to controller 2500. AP light flashing from green,red, yellow, green Below is the repeated log message. I have attached the full log from boot up to the repeating message. *Jun 27 10:30:34.000: %CAPWAP-5-DTLSREQS...

Hello, we are looking to migrate our access points off an AD DHCP server over to Infoblox DHCP server.  We have dedicated subnets for the access points. The DHCP scopes will remain exactly the same between the two appliances. Any advice as to how to ...

Hello Everyone I am trying to setup one Access Point in PI 2.2. Thia AP is installed at 16 feet from the floor but I can't configure it in more than 10 feet. Does anyone have the same problem or know how to fix it up? Thankls

Hi Dears, Do you know inform me what are the maximum number of simultaneous clients can be handled by the Cisco Aironet 1700 Series WAP? What are the number per radio? Thank for all! Allyson