Wireless

Hi Guys,I'm using a Cisco 2504 WLC and two Cisco 1041 Lightweight AP's to demonstrate wireless roaming in single subnet environment.I did the initial configurations and my AP's are connecting to the WLC without any issue. Further as per my setup both...

Hi ,Please provide some tips for wireless capacity management and improvement   RegardsManish

Hi;I use Avaya switch on my network. When i enable LAG on my WLC smth start goes wrong. for exmp: normally there are 3 3502 ap join on my wlc but i enable lag 2 of APs can not join. And i can't ping mgmt interface but i can access http/ssh. when i di...

Hello,I'm trying to find out if Cisco ASR5K supports radius for management purposes? I have been able to find references to TACACS+  but nothing for radius.thanks,Aqdas

I recently had problem with Prime Infrastucture.I found following output when do ncs startari-net-ncs/ncsadmin# ncs statusHealth Monitor is running, with an error.initHealthMonitor(): can not start DBFtp Server is StoppedDatabase server is stoppedTft...

I am deploying an outdoor wireless solution for a customer that requires clients to roam between AP's that will be travelling between 5-25mphI am looking for documentation on outdoor wireless best practice for fast roaming, power levels etc. Using 15...

Hi,I have DHCP configured on the anchor controller but I don't know when DHCP scope is full on it. Do you have any idea or experience how to monitoring exhausted DHCP scope on WLC 5508? Regarding 

Hi all,I am currently in a situation where our primary 5508 failed, our secondary 5508 took over, and we RMA'd the primary. Now that I have received the primary RMA device, I am stuck with what to do with it. I know that I need to transfer the licens...

Hello Experts!!!I am facing issue with a solution providing 2 SSID FRB as infrastructure & acspos for clients. at the remote end I don't have switch to connect AP.Now, I am able to achieve bridge link between two AP but I am unable to associate my cl...

Hi Team,I have just encountered the following problem is this a normal behaviour?  I have a WLC 4400 on the network on vlan 200 and the AP is successfully associated to the WLC on the same VLAN.Recently we migrated to a 3650 CUWN switch with manageme...

Hello team, Setting up a mesh with a 2504 controller and 1552e aps currently and having difficulties in the following fields: - can't provide uplink for the RAP  device from the controller, even the link state don't go up when connect the ethernet po...

hiwe need to install a 3rd party SSL Certificates for Guest Accessin thins lik http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/70584-csr-wlc-00.htmlit is said :The most important information that you need to provide correctl...