Wireless

Hi all,We have a 5508 with 7.4.100.0 vor Internal APs and OEAPs.till now every thing is ok.Now we have to connect an AP (local) in a remote office, connected to the WLC by a VPN Tunnel.The problem is that the AP in the remote office uses the NAT Addr...

Hey guys so we have a client that has mac filtering set up across about 5 or 6 buildings and a core site. They are experiencing some issues when their wireless clients travel between these different remote sites. below is what they sent us:"We’re hav...

After updating the firmware on our 1140s I have two interface issues.  1) I can't see/configure the SSIDs in the web gui.  If I go to security->SSID Manager, none of my SSIDs are list.  2) when trying a different browser, I find that I can't eve logi...

I know this has probably been answered more than a couple times, but I am not to sure what to search for.  We currently have prime infrastructure ver 1.3 and three wism 2 controllers.  When someone try's to connect with a windows 7 machine we have to...

I'm in need of some help, when accessing the device (Web GUI Interface) with username/password "Cisco", I can not apply changes, always returns to the default values​​.In SECURITY section, the "Cisco" user privileges are read-only, no write ........H...

I have a client that has two buildings that are 150 feet apart.    They want a wireless solution that will supprt bridging the two buildings together.   The only problem is, they want a 1 gig link; does Cisco provide a wireless bridge that will suppo...

I have an issue with my engineers that want to mount the AP's on top of a large metal cabinet full of LOTS of electronics, instead of mounting them on the ceiling.  These electrical cabinet contain the X-Ray generator equipment, sometimes using ab mu...

Hey all, I am new to using Cisco Ap's and I am in need of advice for our 1200's. We have 6 of them setup here in our Dr's office for Electronic Medical Records. Each has two 7dbi antennas attached (Linksys I believe). We are continually having connec...

Please visit netspikeslabs.wordpress.com for more information.

Hi all,Recently purchased a 871w, from what I can see all the config is as it should be.The dhcp is working on the fa ports but not the wifi hence it could be a bridging issue:/Here is my config minus passwords. Any pointers would be brilliantCurrent...

Hello,I am having an issue with getting mobility to form between a 2504 and a 5508 controller.  Both WLCs are running 7.4.110.0 code.  The 5508 is the guest anchor.The 5508 has a management interface on the inside network and the guest traffic is on ...