Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
HiI had a 2106 running 4.x software. It was upgraded to 7.x but will not read the config.Can anyone tell me how to downgrade the software?Sent from Cisco Technical Support iPad App
I had configured one access point CAP3602E in flex connect mode through a WLC 5508 after deploying the access point in flex control mode the local mac-filering is not working. before it was working when ap was in local mode. any body have to know is ...
Hi, The issue I'm experiencing is that for some reason some AP's are terminating the association to either one of the controllers for a short period of time. When this happens and the AP re-associates itself with either of the active controllers,...
Hello.For WLC 5508 software version 7.0.235.0, Does anyone know which command is needed to get the WLC send syslog messages everytime a wireless client associate and desassociate?Greettings.
Hi experts,I can't see the dynamic interface for the WLAN that I am trying to create. The dynamic interfaces are manually configured on the controllers, not via NCS. Is there a way to let them show in the dropdown list? Do I need to create the interf...
Can you please provide me with a sample configuration of c1310 as a workgroup bridge.
Hi all,I am running into an issue with disabling the web-auth secure web on an 5508 anchor WLC running 7.2.110. After the WLC rebooted, the guest authentication portal didn't show up...I could see the IE tab showed Web Auth Redirect though...Changed ...
Hi all,I use EAP-FAST in my network and I have some questions about it.1) is there any vulnerability detected with EAP-FAST?2) Can I restrict the establishment two or more simultaneous sessions using the same account and same PAC? how3) Can I use EAP...
Our company is going to have some contractors on site for a long term project. They are bringing their own laptops and will not be on our domain. We want to set up a separate SSID for this group of people. Our IT Security department wants us to ha...
Hi:i have two 1262 one is join okbut one join loop
I cannot seem to get my SSL cert to install on my 5508 controller. I have tried a pfx, pem, and cer. With/without passwords. It transfers successfully, but does not install. And I only get "File transfer failed". I tried on both GUI and CLI.Any sugge...
Do you know if the new 2500 series controller supports things like mobility groups? Could I use 2 of these and do inter-controller roaming.Also do you know if this would work with a 2106 controller and a 2505 controller or are they 2 completely inde...
Hi,i try to setup a Anchor Controller. But the Control and Datapath isn't get up, if the Anchor Controller and internal WLC are in different default mobility groups.Modell: 5508 (both)Version:- Anchor: 7.3.101.0- Internal: 7.4.100.0Anchor Mobility de...
Hey All,I"m fumbling my way through deploying a DMZ wireless controller and I have a question regarding remote wired LANs. My 602OEAP APs support 1 or 2 of their LAN ports as being accessible across the DTLS tunnel.This works fine when they register ...
Hi,I have a problem with WLC 7.3.112.0 web authentication: A client with IExplorer 10 associate and authenticate from correct redirected page of WLC, the problem born at the end of the timeout session time when client is de-authenticated. After its d...
