Wireless

HiI work in a school with a managed wireless system. Managed by the Cisco 2500 controller.My issue is that when the children and teachers log on using a Mac they can not see any of the Windows servers. Most of the work is saved on shares on the Windo...

HiI work in schools and we have a couple of schools that use a cisco managed system. The guys who installed it suggested that we can use the AP's or box to push out proxy settings. They didnt however tel me how and are very good at communicating.Does...

Hi allI would like to ask about vlan configuration on access point Airone1242.Is mandatory connect it into trunk port on the switch ? , i will use only one Vlan through one SSID exept of native vlan. I m going to connect it into access port on switch...

                   Hi All,I’m having a problem of joining new Aps( Ari-ap1242G-E-k9 ) to the following wireless LAN controller. WLC details as follows, Model No - AIR-CT5508-K9Software Version - 7.0.116.0 AP Model - ARI-AP1242G-E-K9 AP console logs a...

Hi Fellow Cisco Techs,          We have implemented a 802.1x system using the WCS/WLC code 7.2 and 3500i AP series using CAPWAP. The authentication is done via ACS4.2 and proxied to AD from there. What I notcied was that in the passed log on ACS, the...

Hi,I have 2 cisco Aironet 1252 setup as a point to point link using an external antenna (one radio is setup as the root bridge the other is setup as the non-root bridge). Now I see that the connection between the radios is established at a speed of 5...

We have a WLC 4404 with about 85 1121 and 1241 APs. -  I just added 6 new 3501E with Antennas, and configured the a new SSID, but non of my clients can connect to any of the 3501s.   One solution from a tech was to update the NIC drivers.   I verifie...

WLC 5508 7.0.116.0When configuring an 1142 in OfficeExtend mode, the device connects and a DTLS Tunnel is established when behind the firewall.  When testing from a port outside the firewall, the AP fires up, but loses it's configuration - the AP rec...

Hi All, Im looking for possibilities to remote recognize attached antennas to AP1242. I have a lot of devices which not working properly. I think most of them have only one antennas installed , but I cant be sure if its fitted into primary connector....

                   Hello,  I would like to install three antennas (2450S) on some AP1261 that i wold spread out 10 feet apart. I am not able to get the antenna on the C connector to transmit. I am not using 802.11N. This is for a warehouse where all ...

Hi,In ordering guide, 1522 are designed to withstand power surges on the AC power cord up to 4 kV as per EN61000-4-5 Level 4 & lightning arrestors are not required.What does it means? I've install the AP outdoor & using ant58g10ssa antenna. I'm afrai...