Wireless

I'd like to TFTP download a config file that will restrict 802.11a channel use to 17dB channels.  Is it possible to bypass/process the annoying mesh stranding (y/n) prompt from within a config file?  Or perhaps disable mesh (or prompting) altogether?...

I've added several switches and one WLC to my new NCS Prime box. I don't see them in the display. If I try to readd one, it says it already exists. What am I missing?--Patrick

Hi,I have deployed 15 x AIR-LAP1042N-E-K9 with a AIR-CT5508-25-K9 into a grade two listed building, it has 18inch thick concrete/brick walls which are seriously hindering signal propagation.  I am not allowed to drill any holes to extend the cabling ...

Hey Folks,We have a client that was using Eap TLS i think and their PKI Cert have expired.  I took some notes so I appologize if this question is incomplete.  ACS 4.2 is also being used.  ?Can someone point me to the right document on how to renew th...

We are looking to consolidate our guest wireless. Currently, we have multiple controllers 4402 or better running 4.2.207 across our environment. In some of the environements where these controllers sit there is a dedicated internet connection for gue...

Hi all,I'm interested in the communities opinion in relation to DHCP provisioning when using auto-anchor/guest tunneling.As far as I can tell, one cannot use the internal DHCP on the anchor controller when using auto-anchor due to incompatibility bet...

Hi I would like to ask some question on WLAN technology, which I using WiSM version 2. And i get requirement that user must be restrict with SSID, so, i found that it can do it on ACS version 4.x via NAR for SSID-based authentication feature. Then, i...

I did some searching but couldnt find what i was looking for so figured i would ask for help.We use our WCS to deploy software and config on our WLC's (approx 100)We don't need to manage/monitor the Access Points on our WCS only the WLC are needed.Is...

Hi all,I can see the web auth bundle:(Cisco Controller) show custom-web webauth-bundlebox-bottom.gif              box-left.gif                          image.gif                                        login.html                                       ...

Hi,I have deployed a Cisco AIR-LAP1262N-E-K9 in a big auditorium space and I am not getting good/enough coverage. What antenna/s do you recommend me to get more coverage.Any help is much appreciated.

I have some clients running Vista on an HP laptop with a b/g card that has issues connecting to a 3502.  I am able to connect but traffic does not pass.  I can with the same client connect to a 1142.  Both AP's are Lightweight and connected to the sa...

I've been getting warning messages from the event log of a 1300 series bridge, which is set as an Access Point in the network, states: 'Packet to client (mac address) reached max retries, removing the client';  I'm not sure why the client is removed....

Hi,I need some advice, I have installed a AIR-LAP1522AG-E-K9 with 3 x AIR-ANT2480V-N antennas and I am getting just 60 meters coverage, I can't believe that is right, could anybody please help me.I do not undersand why the range is so limited.Any hel...

Hi,We have a problem regarding RF Grouping between two WLC 5508.The two controllers have the same RF Group name,RF Grouping is enabled,they belong to the same mobility group,their management IP address is on the same subnet, they ping each other but ...

I have a autonomous AP (stand alone) configured for an SSID that uses WPA-TKIP. I can connect to that SSID using "g", "a" etc but I cannot connect using the "b" radio.I already checked all the data rates and power settings and I cannot figure out the...