Wireless

I have configured the WCS server and all the maps, the WLCs are registered in the server.I have the following question:I can see all users, who are associated in a floor.Today I can only see the recent or current location, when I select a specific us...

Hi,Does anyone know if it is possible to change the source address for aaa authentication requests leaving Wism to the server ? I need to have these requests leave from an address not on the same subnet as the management or ap management interfaces.S...

I just recently installed a RV220W at my office and (almost) everything works fine. I have noticed that when my iPhone is connected to the RV220 wi-fi network, I get the message "The connection to the server failed" when checking my email. If I disab...

When trying to order but on the configurator show the following warning:2.  IMPORTANT, Software application support for the Context-Aware license for Tag tracking must be Ordered Separately from AeroScout. Cisco provides software application support ...

What is the best way to setup a very high density WLAN area.Such a a conferencing room with 300+ users, which all will be using WLAN connectivity.Is it possible to use several 'g/n' AP's in close range, eg with directional antenna's ? Maybe by antenn...

I had upgraded the MSE to 7.0.202. Release code. The Upgrade along with the 4 database zips went smooth.But the MSE status shows followingIf anyone can help me or shed some light into the scenario. Thanks

Hi TeamCould you please share the point to point wireless connectivity configration procedure using 1410 bridges either using GUI/CLI .We have setup this in one of our Client sites.Awaiting your reply.Thanks in advance!RegardsUnni KannanSystems Engin...

I'm looking for a solution/advice to our webauth WLAN. When a user connects, I want them to get a private IP. Once they hit the authentication page and logon, I want them to get a public IP. I have a lot of devices connected to the WLAN, but they're ...

Hi all,I have here in the work a wireless lan controller and 4 access points in the network. Everything was working fine until yesterday ( and I don´t know why...)The leds of the ports of the controller are blinking and the status led is blinking and...

We need to allow a certain AD group to authenticate to WCS as a lobby ambassador. I have an ACS 5.x, but there is very little documentation between WCS 7.0.116 and ACS 5.x. Any links or suggestions?Sent from Cisco Technical Support iPhone App

Does anyone know if and when the Aironet 802.11/a/b/g PI21AG will support Windows 7?x32? x64?We are using this card and plan to migrate to Windows 7, and I am in charge of testing to see if the Aironet will work.Do you know if there are any alpha or ...

Hello,we have a few access points connected to a 2960 cisco switch which in turns connects to 3560 Layer 3 switch there are two vlans (vlan 1 (192.168.10.0) and vlan2 (192.168.20.0) )..currently all users (including wireless) users are on vlan 1  whi...

HiCan anybody suggest, wether Heat Maps can be generated via WCS BAse license only or do i need WCS with Plus lic and Location Services Appliance.RegardsAtif

On the ASA if I have an inbound static mapping (public address, private address), does that same NAT apply for outbound traffic automatically or will it use my NAT pool?