Wireless

It doesnt seem I am able to change the SSID of an active or disabled wlan via the web interface ?Any ideas ?Cheersdave

Hello,From the WCS > license center. we have registered the WCs and MSE. Do I need to register the controller also to get the mobility devices shown on the heatmap?WCS v7.xMSE 3310Controller 2100 v7.xthanks

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:...

hi,i have WLC and cisco APsthere is already one ssid broadcasting.i want to broadcast two more SSIDs.what are the settings?

Hello,We have WCS version 7.x with WLC version 7.x and MSE 3310.When I checl the  map-area on the WCS I cannot  see clients icon, when I click on the left pane (under Clients) I have error message popup seeing (There are no clients on this floor. Eit...

Hi,While appling tenplates from WCS, i getting status report error message AP Group VLAN "Feelgood" does not exists on controller.I have double  checked the perticular AP group WLAN is created & mapped to the correct interface in the controller. This...

Cisco892Wの設定をしています。CPExpressで初期設定を終え、CCP（Ver.2.4）で基本IOSの設定がほぼ終わった状態です。有線接続でのインターネット、メール送受信等々は正常です。CCPからWirelessを選択して設定を入れ、画面下部の「Launch Wireless Applocation」ボタンをクリックすると、IEのウィンドウが開きHTTPSでBVIのIPアドレスに接続しようとしますが、「接続できません」と表示されます。URLを「http://192.168.0.1<BV...

Hello,Could some point me to a document which specifies the switching throughput for a Cisco 5508.Data sheet only mentions vague statement.High Performance• Wire speed, non-blocking performance for 802.11n networks.Thanks,Janesh

Hi Expertson the Controller when you define the radius server , do u need to add the same shared secret key which y have defined on the acs server towards the controller

Hi Folkswhen y authenticate WiFi Users Against acs , is the only thing in wlc side just to point it out  to the acs i defined wlc in the acs as radius Protocol Airspace

I am not sure if this is the right forum to ask this question. I am not the expert in WLAN system, but I need to find an AP for a test. Basically I need an AP so that I can fix the data rate to one value(for example 54Mbps) and test our client device...

Hisuppose ur controller support up to 50 LWAP,and later on y want to add another 25,now what should y do?buy license for that or replace the controller by one support 100 LWAP?Thanks

Hi;I am facing an issue with WCS heat maps. Heat maps are not showing for any of the access points. I am using 7.0.164.0 WCS version and 1252 access points with 5145 antenna. We are using only 5 GHz and 2.4 GHz is disabled.Does any one has come acros...