Wireless

I have 90 1130A/G pure autonomous AP site. I want to deploy a 5508 controller, convert all APs to lightweight, and do it all remotely. I have full access to all the APs and can build the controller in any way to support this. Anyone have any ideas or...

Hello, I have six 7920 phones attaching to four 1242 autounomous APs. In a retail store environment. Users have complained about calls becoming distorted or dropping quite frequently. I can see the phones roaming from AP to AP and the lowest signal s...

Hi I have a wireless network using AIR-LAP1131G-E-K9 in indoor, AIR-LAP1310G-E-K9 on outddor and a wireless LAN Contrôller 4402 to contrôl all the APs.In order to increase the coverage of the outdoor AP, I have planned to use 802.11b for AIR-LAP131...

I am trying to design Video Surveillance Solutions for foot ball field. Here, we can not pull cable from cameras to MDF the building in Campus Environment. I am trying to incorporate Cisco bridges (Point to Multipoint Environment) in order carry data...

I have 90 1130A/G autonomous AP site. I want to deploy a 5508 controller, convert all APs to lightweight, and do it all remotely. I have full access to all the APs and can build the controller in any way to support this. Anyone have any ideas or whit...

How I can configer Point to Multipoint Bridge ?one WAP200 Bridge --> Two WAP200 Bridges in different buildings.

Can a 3200 MAR ISR serve as an IPSec endpoint to allow all traffic connected to the MAR to traverse a tunnel? Or do the connected clients all have to run VPN client software?

We have two sets of 1310 bridges that have been setup point to point from our main building to other buildings on the campus. When they were setup originally they were configured with one SSID and a 802.1q configuration for each allowed VLAN. This wa...

Hello,I am having disconnections in a WLC4402. The clients are having intermitent connection to APs. I had updated OS from 4.2.176.0 to 4.2.207.0 because of TAC suggestion. The engineer has verified some show comands as well as a debug client. But it...

Hi,I am reading things about the 802.11n standard, but I have some things that I do not understand very well.So, can someone tell me what the maximum bandwidth in the 802.11n standard is?That bandwidth is dependent, if I used a 20MHz or 40Mhz channel...

I have 2 different AP models (1130's & 1140's) for which I want to create a DHCP pool on a core layer 3 switch with an Option 43 pointing to the Wireless LAN Controller. In conjunction with the Option 43 entry however, I need to specify the AP type a...