Wireless

I am upgrading via http. In the instructions it say's to disable the controller port-channel then download the code. When you disable the port-channel you lose connection to the wism. am I missing something? how would that work?

Hi Experts,I want to implement a guest login for the WLAN, but the redirect of Guest login webpage is failing. Could some one assist what needs to be configured.Thanks in advance,.RegardsNeha

Have 5 1240AG's and want to use one as WDS and Local Radius Server.Am using the following as a guide:http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801c951f.shtml#hwThe above example uses a Cisco Secure A...

Versions 6.0.182.0 on controllers (4 WISMs) and 6.0.132.0 on WCS.Created a test WLAN which was used for a week or so, WPA2/PSK, broadcast ssid, standard stuff. I no longer wish to use it and set the enabled state in the template to disable and then s...

I just recived a WLC2106 and 6 ap1142. I seem to need to upgrade the ios on the wlc to 5.0, it came with 4.0.2. I cannot download the ios because I do not have a support contarct or cco. Why sell a WLC without the right IOS.Please help.

Folks, I have two wireless bridges about 200 Meters apart from each other. Everything has been working good so far. Lately I have noticed that the performance has gone done of the bridge, I am not sure where to start, any help would be highly...

I have a few 7920's purchased used. I cannot get into any configurations as it states "Not Available". I cannot use the Admin keystroke, does not work. The USB interface cannot be enabled so I cannot use the 7920 software. Any other ideas?Thanks!

We have a 44XX WLC setup for a simple wireless network. However, the Access Points do not register with the WLC. Thanks

I have a few APs that will not complete the code upgrade process after the controller was taken to 5.2.193.0 When watching the debugs, the AP starts the image data process, reaches the data transfer done point and then the AP heartbeat expires. The ...

What is the maximum number of users that one Aironet would allow without the disruption of service?

We have lots of workstation on wheels. We use EAP-Fast with Cisco ACS for authentication. When a user isn't in front of the WOW and the PAC pop-up times out, it disables the WOW and causes problems.Has anyone used some form of auto-accept method wi...

Does anyone know the differences between the releases? And why is there a NOTE in the release notes for 6.0.132 that states: "Note - Any release posted after 5.2.130.0 will not be eligible for upgrade to release 6.0.132.0."

HiI have wireless LAN Controller. I have enabled WPA. I have AAA (CISCO ACS) Server for authentication.I have individual username passwords for wireless clients. But the same username password is been used simultaneously by two different users. I wan...