Wireless

Under the 'Rogue Summary' on our WLCs we sometimes see some 'Active Rogue Clients' and 'Adhoc Rogues'. I'm just wondering if this is 'FYI Only', or am I meant to do something with this information? I've tried MAC Filtering and/or adding the offending...

This is what I hope is an easy question: can I do a point-to-point bridge with a wireless lan controller (4402 running 4.2.176.0 if you need specifics) without running a mesh version of the code? Can I do it using 1242 AP's?Thanks in advance....

Hello,I have a lot of alert messages from my APs and I don't understand what it means exactly.Can anyone help me?Here is the message (on DFM - Alerts and Activities):Event_Description OperationallyDown Component PORT-AP-1200-VINC33/7 [Fa0.1] Type L2V...

I am deploying a new LAN Controller and 1142N APs. Even though I have gone through and verified that all the N setting are enabled and what I believe to be correct, I can still only see the G or A networks from a laptop with an N card.

Hello,I have a LAP1252AG-E-K9 managed by a WLC embedded in a Catalyst3750G. My question is the following: how can I disable the 5GHz radio module using the WLC (I desire leave only the 2.4GHz module). In addition : in case I put in the LAP only 3 2.4...

I have a NM WLC with four WLAN SSID and 8 APs, I want to broadcast the four SSID in 7 APs and just one SSID in one AP. Is ther a way to do that?Thanks.

Hi, Every evening, my access points disconnect from the controller. I have to reboot the controller for them to re-associate again. I don't know what iscausing this. Has anyone seen this before? Any advise will be much appreciated.WLC4402 version 5.0...

Hi, I have a Cisco wireless controller 4402. And it have connect 15pcs Cisco Aironet 1130AG Access Point which is running on LWAPP. A couple of days ago, all the AP to start to random reboot. The reboot reason which I check on the AP is ******** Rest...

I have a situation where I'd like to run aironet 1252's with dual radios that require 18.x W per port. I understand that Enhanced PoE will support up to 20 and am at the software rev on my 6500 that supports it. However still no go. any ideas

Hi all,WCS ver 5.2.110.0When I create a LWAP template, to apply a WLAN override to all my APs, the WLAN I'm looking for is not in the list. Previous WLANs are listed, that are no longer resident on the WLC4404. The current WLAN configured in the WLC ...

Hi, I have a doubt with AP1131,the AP doesn't permit traffic to internet, I need do something in the router?In the AP I configure a static IP and the gateway is the IP to my router?thanks

Hi,Hope you can help to provide some explaination or guidance.The following messages appeared in the wireless controller deployed in my customer environment'Malformed SSID information in sniffing dump from AP'Can anyone explain the cause of this log?...

Hello,I have configured a Wireless LAN with two WLC 4402-25 and 20 LWAPP 1131G. I would like to make WLC failover for the LWAPP APs. So I have registered all the APs on the First WLC. Then I have configured the first half of LWAPP with primary contro...

I have an interesting problem. I have an aironet 1250. For months my wireless clients has been connecting with no problems. One day there was a power failure, don't remember making any chnages which I should of saved. After, all of my equipment reboo...