Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
First I'll say I'm not a Cisco engineer, but I do know wifi and controller software from other vendors.We recently activated 5Ghz (2.4Ghz was already enabled) for a SSID in one of our locations. This location has >160 AP's and roughly 1,300 client d...
Resolved! Wifi disconnect troubleshooting help
wireHello,We have a Cisco based wireless enterprise based on 5508 WLC's (Firmware: 8.5.171.4). We are struggling with periodic "disconnects" of Windows based clients. I'm not a cisco expert, but am fairly well versed in WLAN's in general and Window...
We need to disable this in our environment and currently we have to do this one ap at a time. Can we configure this via WLC so that any AP that joins will have this setting? Note that we are using C9130AXI-B AP running on 8.10.185.0 code version and ...
Hello, guys. I'm having a problem registering an AP 1852i on the controller. WLC VER-8.5.151.0 It already had a registry but after a reboot of the controller, when it tries to register, the following errors are listed:*05/14/2023 17:08:53.0150] CAPW...
Salam,I have converted one Access point from capwap to Mobility Express by TFTP server. Now i have web access as attached below pics. I need to add another access points to this AP Controller, but when i am getting error as attached.I tried also for ...
Hello, i have an issue with an installation involving AP1850 and software 8.8.100.0. Out of the 15 access points, 3 are not showing up in the controller. These three access points have been in their boxes for 2 years, and now we have tried to put the...
Hi All,We are a meetings center so we run custom WIFI networks for events and conferences. We have been using PI for years for reporting and that has been great. We are now upgrading to 9800 controllers and with have DNA Centre. What is a good want...
I have a small network with three Cisco 240AC APs.Recently some client devices have failed to connect. One such device is 2c:9e:00:56:d9:86.An extract of the log is below. *apfMsConnTask_0: Jun 05 18:37:31.035: %APF-5-CLIENT_ASSOCIATE: apf_80211.c:1...
Found Hardware Faulty for Cisco AIR-AP1852I-S-K9C and cant power up
Hi thereI can't access my AP. Initially green light blinking then Red and OFF.What is the solution ?
Resolved! C9115AXI-A
Hi Team, In C9115AXI-A do I need to have a controller for this? Or this AP can run without controller? Thank you! -Mike
Hi,I wanted to create two ssid with same name and encryption but both the ssid on different VLAN.Have created two AP group and can map to each of the AP and wanted to roam between to AP with same SSID/encryption but different VLANs.When I roam to ano...
Some of our access points have problem recovering after a power interruption (No UPS). The clients connected to it are getting the IP of the Access Point as DNS. We need to restart the AP to restore the correct DNS of Clients.- We have a separate DHC...
Hi all, Background: I have two WLC 5500, which were performed in HA mode, but I just disabled the SSO in primary just now, and then the secondary went to the maintenance mode. Issue: When I want to make them back to the HA mode, I found that I forg...
Hi guys, I have 300 AP in the Cisco 5508 WLC. I have to change the mode of all access points from flex connect to local. Is there a way to change them all at once?
