Wireless

Hi all,I have a Cisco 871W, but no experience .. My connection is 100/100 Mbit. And I have four PC's connected to the router. One in every connection. But now every PC gets about 25/25 Mbit. The router seems to split the speed. Even if only one PC ar...

Hi all,I need urgent help. I need to boot ourAP to rommon, but It doesnt accept break sequence Ctrl + break. I use putty as connection client to console port of AP.Any idea?BRjl

Anyone can clarify me if is correct or not to confifure the WISM controller on a 6509 management in VLAN1 or is a must to put ( as Cisco Described : http://www.cisco.com/en/US/docs/wireless/technology/wism/technical/reference/appnote.html#wp40841 ) i...

I have an issue where wireless coverage is very low, its so low you can easily something is wrong with AP transmit power. I looked up controller it shows transmit power level is 1. AP is Cisco 1130AG connected to HP 3500yl-48G..I observed on the swit...

Ok..perhaps I am a big dummy but I can't find any really good documentation on how to setup a 4400 in a DMZ for Wireless guest access. I know you wouldhave to setup mobility groups and make sure you can ping the controllers across thenetwork.. I am j...

Hello,I just upgraded an Aironet 1121G access point to IOS software version 12.3(8)JEC2 (file name: c1100-k9w7-tar.123-8.JEC2). I noticed that the HTTP web interface now times out after an inactivity of just a few minutes (dont have an exact number, ...

Hello,I have 6 users on a small WLAN. The AP is an 1100 Series, and I currently have no WEP encryption enabled (nor WPA) for testing purposes. The network has worked fine for a few months without any disruption, however I now have (2) of the (6) wire...

We're running the LWAPP with the WLC's model 2000 and AP's modelAIR-AP1242AG-A-K9. We assign static addresses to the WLC's, however DHCP addresses forthe AP's. We need to obtain the config from the AP, however were not able to ether telnetor http/s i...

Good morning guysI have a 1121 AP and manual PAC provisioning passed but automatic does not. What debug statements can I use to troubleshoot this? I'm also using local RADIUS on the AP and CSSC 5.1.0.39 which I believe does not support manual PAC fil...

Is it possible to allow client use the Web VPN connect to the company for register the SoftPhone ? My customer ask me this question and I have no any idea. He prefer to not use the Cisco VPN client and he want the other type of VPN that can run via b...

Hello,Two of our wlans are web authentication types. A lot of the time people are connected to one of them but not authenticated. For example we'll have a 1000 users connected but only 200 are actually authenticated and doing something on the network...

HiI am increasingly finding the linksys USB adapter 802.11g takes longer to connect to a Netgear router. Sometimes, I have to restart the laptop few times. The router is fine as I have another laptop which connects fine via ethernet cable fine. Any s...

On at least 2 of our access points, it looks as though the total output drops are high for some APs that have very little client traffic on them. Our network monitoring system (OpManager via SNMP) has been generating alarms for high discard and error...